Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We have a Subscriber and a Publisher CCM 4.1 servers. I have set up my Dial Peers to use both of them. Basically I want to have it fall over to the other server and if one server is down for any reason and have it fall over automatically. I have a...
Is there any way to hear a busy tone and put the call on hold when the phone is busy talking to another user ?What I mean is that normally the caller hear a ring ring sound when the phone is busy with another line. Can we change it to beeb beep....
I have a Cisco IP Communicator 7.0 running on 2 computers and the time is GMT -2 on the IP Communicator phones while the 7940 desk phones all have the correct time (EDT or GMT -5). These are connecting to a UC520 system. Any ideas where to look? T...
With CCM 6.0.1How many people can be on a meet me conf callHow many people can be on a ad hoc conf call
Hi to all,I install for my first time the new phone 524SG, all works fine except the "CME services", when I select it I obtain "Failed". I use the UC520 default configuration for URLs, the firmware is the last one 8.1.13, the UC520 IOS and CUE also a...
I defined hardware conference bridge resources in a voice gateway, my question is do I had to define transcoding resources in the voice gateway to establish a conference with two ip-phones in the same LAN (g711 region) and one ip phone at a remote s...
Hi all,Currently, we have unified messaging 4.21 with exchange 2003.Soon we will upgrade to unified messaging to 5 or 7 to compatible with exchange 2007.However, our unified is running on windows 2003, but exchange 2007 will run on windows 2008.It mi...
Currently, a 7921 phone is setup as a single line. Can I just change it to a dual line? It says I need to remove and readd the ephone-dn. Is dual line supported on the 7921?
Hello,I am trying to make changes to a phone which is an 6.1.2 cluster and it doesnt take the changes. I am not able to reset the phone from callmanager either. DB replication looks good. Any other ideas would be helpful.Thanks
I've done some searching and just wanted to confirm. Is it safe to say that Cisco does not offer an Intercom product which intergrates with Call Manager? My boss is asking me to check. He does not want to use an IP phone with an "intercom" line but r...
Can somebody please tell me how to exactly restart the services that run the Attendant Console?
If I have to configure 2 mixed mode and 2 g711 conferences, with max-sessions as 4 on cli, how do we prevent 4 g711 sessions from occurring since max sessions is for all type of conferences under that dspfarm?
Hi All, I have a customer that would like to use 2x FXO card as backup to there ISDN My simple thinking would be to use a H323 GW trunk the FXO and ISDN and use the preference command to make use that the ISDN is always tried as a first choice. Unles...
The customer did not purchase CCX server or CAD? Is there anyone to do this without CCX server and CAD? Can they deveope their own screen pop with some tool kit? They have CM 7.0 Unity 7
Can the keypad be unlocked while phone is ringing or on an active call. I have the need to send DTMF tones after answering a call. If I unlock the keypad before a call comes in I can send DTMF.
