IP Telephony and Phones

On the received call list of a 7921 wireless phone, it is showing the same call listed in every slot.  The same call meaning same calling party, same time repeated over and over.  Is this a setting that can be changed?  The software version for the p...

Hi,I am running CME Version 3.3 on IOS 12.24 (23) main train. I've lccal directory enabled under telephony-service but none of my phones show "LocalDirectory" option when directories button is pressed. Only placed calls, received calls and missed cal...

Anyone know an easy way to check when a CM4.1(3) user last logged on using extension mobility. (integrated into our microsoft AD)I want to be able to check to see when logged out profiles last logged on for housekeeping purposes. Nobody ever tells me...

I have a few questions regarding the proper installation of a Unity 5.x voice messaging server when it will be installed into an existing AD that contains a single Unity 4.2 voice messaging server. The new 5.x server will also contain it's own versio...

Hi,I want record a voice calls in my Toip installation.I'm using CUCM 7.0 and for the voice record Speechlog.I have installed wireshark to verify if the server receive the sniffing Voice traffic.I have verified that I received the signalling protoco...

Hi,I'm setting up a sip trunk from a 2811 running IOS 12.4.22T to our provider.I have configured the authentication on the SIP-ua and a dial peer that sends outbound calls to the sip server 9see config below)dial-peer voice 99 voip translation-profil...

HelloI saw that several people had problem with a QSIG connection between CCM and a PABX.I have the same problem, i.e when I call from an Alcatel phone to a Cisco Phone through a QSIG link, if the Cisco IP Phone has a CFA configured to an another IP ...

We have a centralized IPT build with four remote offices. Some of the offices use 9 to dial out and some use 8. It was suggested that we try moving everyone to dialing the* key for outside dialtone. I am just starting to research this and I am won...

Hi,I have configured on CME three dial-peers as following:dial-peer voice 101 pots preference 1 destination-pattern [0,1,3,8].T port 0/1/1!dial-peer voice 102 pots preference 3 destination-pattern [0,1,3,8].T port 0/1/0!dial-peer voice 105 voip trans...

I brought up this question sometimes ago and I did not receive any answer. So I rephrase my question. May be the question was not clear.What advantage I gain when creating trunk between two call manager in two different cluster? I can achieve similar...

Hi!I would like to configure a hunt group with 3 phones. If no one answers or if they are all busy I would like the call to be forward to the voice mail. Is it possible? Where/how do I configure "the forward to the voice mail" part?Thanks,Ana

I have a large customer who is planning a CER install with approximately 5000 IP phones. The customer maintains a database of switchport to location mappings through a separate application because they do several port moves, adds and changes a week....

Hi, Managed to setup ntp references with my cluster butt then had to change the names of the servers at the last minute. Anyhow, the subscribers are still referencing the old publisher name as the ntp reference and hence cannot get the correct time. ...