Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
hello,i want to configure a CME for the first time. i would ask if there is any utility that i can use to configure CME easily ( like web utility..).Menay thanksHicham
Running dbWalker on Unity Voicemail Only 4.0(5) I get this error;Directory Walker(error) internal dbWalker error =-94 (invalid use of Null) in procedure checkForOrphanedStreamFiles of Form frmMain
Hi,We have deployed CUCM version 6.1.2.1002-1 and have a mixture of 7945 & 65 through out the campus. When you call IP to IP it use G722 and the quality is fine, when add a conf call it converts it to G711 and then start to get noise in the ear piece...
Hi all,I have recently setup our new UC500 system (UC520-24U-8FXO-K9)We've got the T1 card as well (VWIC2-1MFT-T1/E1)I have received, from our provider, Telus, a T1 partial PRI with 10 channels.I have plugged this in as instructed, but no matter what...
Hi all, We have a cisco IP telephony network with call manager version 6.0 server. The caller id for the incoming calls is showing only 10 digits. We are unable to see the complete number particulary international numbers. Is there any configur...
Hello Folks We have a customer who wants to reduce the time that the ip phones takes to recover from the srst mode to the normal bahavior in call manager. We have the default timer but we wonder if there could be a timer that coud be modified in orde...
Is there anyway to change the behavior of the auto answer configuration for each line? Clearly, it's either on or it's off. But the customer has an old key system that auto answers internal calls, but when external PSTN calls come in, the phone rin...
I have a client with a Cisco MCS7800 series hp dl 380 G3 server, Mirrored Array, (2) 36.4GB Ultra320SCSI 10K drives. Server 2000 SP3(1) drive failed, replaced drive, raid will not rebuild as HP support says the remaining drive is also in pending sma...
I'm having issues with my CCUM 6 where my phones will not obtian an IP address, they just sit there with the mesage 'Configuring IP', its the first time I have used version 6, the last time I configured CCM from the ground up was at version 4.1 which...
When do you get the option of going back to Windows based sever for CUCM and has anyone done so and for what reason many thanks
Can a user do it like you can in CME.?
Dear All,Confused and need your expert input in this regardsSITE A is HeadQuarter and Site B is a branch. Setup looks like this :-Site A calling Site BIP Phone Network(SiteA)--->CCM5.x (SiteA)-->LAN NetworkA--> WAN RouterA--> WAN RouterB-->Branch LAN...
Hi there,I am using an IOS H.323 gateway and I only use voip dial-peers. NO pots dial-peer as this is a lab environment and I do not have access to PRI or PSTN lines. Obviously some pots dial-peer commands are not supported. Now the question is: what...
We are trying to set up the call holding queue for unity 5.0 with unified messaging and UCM version 6.1(3). In the call transfer page of a subscriber I have the Transfer Type on the call transfer page set to Supervice transfer wait for 2 rings and a...
I have two CME sites connected by VPN and H.323CUVA does not work accross two sitesPlease Help
