Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I'm trying to set up our system to provide the Called ID of the DID that originated the call. Presently, the only ID shown is the main number. I have each DN's External Mask showing the DID number. Is there somewhere else I need to configure?
I need to remove SCCP from a voice gateway 224 and reconfigure it as MGCP. I`ve deleted references to SCCP but the voice port are still SCCP . What is the best way to remove SCCP and so re-configure the GW as MGCP. Is it easier to erase Start up ?tha...
Hi, somebody know that the forward all does work if line is in hunt group?Regards
We just rolled out several 7942s as replacements for old 7940Gs, and most of the users are complaining about poor sound quality. It seems to be related to the wideband handset, since it improves when we swap in a standard handset.We are running CUCM...
Quick question: If a PRI has been ordered and provisioned to use ISDN protocol "NI-1" what does this correspond to when configuring the "isdn switch-type ????" command on the PRI?Do I use "isdn switch-type primary-ni"?TIA for any assistance
I believe I've been told it's possible to migrate from having standard DLUs to the CUWL scheme. Is there anything that anyone has came across that outlines this process? I can't seem to find any.Thanks.Craig
I'm having problems with my telco reclaiming ports because they are not being used. I have a device that can place a number of calls to my 5350s, but the calls require the terminating end to press 1 to keep the call up. I'd like to take the attached ...
The publisher and all subscribers have the Max Records field set to 1500000 records and yet the CallDetailRecord table is currently holding 9670938 rows. The oldest entry is not being purged at night either.The Maintenance Time is set to 24 and Main...
Is it possible to offload the CCM End User options page onto a seperate server?
Can I enable MLA on Callmanager that connected with IPCC and IVR?
I configured the "max-conn" parameter on my H323 voice gateway (see "dial-peer" here below).When the maximum number of calls is reached, the calling party receives the "out of order" tone.Is it possile to configure something so he would receive the "...
Hello, Let's say first and foremost, I'm not a voice guy. I'm trying to get a voip lab setup and I'm having strange issues. I have CCM 4.1(3)sr4d with an IP Communicator soft phone and a 7961 IP phone. The out side connection is a SIP trunk provi...
I am trying to trunk an asterisk and CCM 5.1 to each other. Inbound from the asterisk works, however outbound to the from CCM to asterisk does not :(. I was trying a normal route pattern and now I see SIP Route Pattern. WHen I try to add a SIP Rout...
Hi, I've specced this up for a customer. I've also added a VWIC2-1MFT-T1/E1= . I dont need to order any DSP's do I? ie they should come as part of the bundle surley?
I have CME 4.2 12.4-11.XW6ATA ver. ATA030100SCCP040211A.zupGroup Pickup **4(group #)with Stationary ATA phone works O.K.Group Pickup **4(group #)with DECT ATA phone DOESNT work.Pickup **3(dn #)with Stationary ATA phone DOESNT work.Pickup **3(dn #)wit...
