Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
IS there an easier way to load configuration settings for 100 phones onto CME 4.1 or do we have to configure per ephone?
When I install CUCM6, I get "security configuration failed" and it goes to Database Access Security password page.I am quite sure that I put the right password and NIC car is connected to the network, I even can ping the server ip address after I res...
Hi Experts,I been receiving this alert:Alert: Transmit % Utilization of "Call Manager"-MC TCP Loopback interface is 100%What could this mean?How to troubleshoot it? where to look?thanks for any help!
Good day, our company has a new CCME3845 Router and we want to know the difference of NM-HDV2-1T1/E1 and VWIC-1MFT-E1 before we place an order of this module.
Hi,I have a core switch catalyst 4507 and edge switch as catalyst 3560.I need the igmp configuration on the switches. I think I need activate multicast on core switch then activate on edge switch.They will be used for IPTV system.Please help me asap.
All, Ive been working with this all day. I get about 30 minutes or so into the install, and it bombs out. Here is what the error message says, see attached. I have had sql 2005 (not suported) and now I have msde2000 running. Still same issue. Doi...
Has anyone gotten this to work successfully? I am using RightFax with SR140. The call goes out the PSTN and connects to the far end fax, but cannot negotiate the proper RTP. I have verified all codec, relay, etc. MGCP T38 is supposed to be supported ...
I need an advice (as detailed as possible and i will rate helpful posts ;))Im going to migrate our Cisco2811 gateways from H323 to MGCP. The two Gateways have 2 Pri E1 each and are connected to Callmanager4.x (1Pub+1Sub). We have 1Route List with 1Ro...
My understanding is that when setting port security on POE ports that have Cisco phones and workstations plugged thru phone, is that you should allow three mac addresses.one for workstation in workstation vlanone for phone in workstation vlanone for ...
Anyone know what this means during a unity 4.0(5) install? "There were problems installing the skinny TSP, please run the skinny TSP setup after the Unity setup completes."
I recently changed the time on the Voice gateway and now I have corrected the clocks on all our phones. I am afraid that I will always have to do this. Can someone please help me so that i fix the DST issue here permently. I was thinking of config...
Can anyone point me to a link which lists approved headsets for the 7941G/7961G models?Thanks.
I have a call handler that accepts user input (ext's). I send the caller to "subscriber system transfer". Works for extensions that are subscribers. However we also have 4 digit dial to nortel phones on the other side of a QSIG trunk. Of course we ca...
HiOur client is using CME 4.1 with ISDN E1 Pri connected to PSTN, the client bought a software to record all calls both internally and externally. When calls are done internally they are recorded perfectly, but calls to/from PSTN are recorded with a ...
Is it possible to restrict a device from registering during SRST mode? and if so, how would it be done?
