Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is it possible to update from Unity Express to Unity and also Call Manager Express to Call Manager? If so what are the costs involved?
Hi ,Can I get any document for how many IP phones(max.) are supported on MCS 7800 ?regds,aman
Our Receptionist having 7960 with 7914 module unable to see incoming Numbers on expansion module buttons, all calls with numbers appearing on phone screen only one behind another. All numbers must be appearing on the side of expansion module so it ca...
I have a client with 900 nodes moving toward Cisco IPT. They currently have Microsoft Active Directory Infrastructure.What be the best option for Cisco IPT Servers? Would it be beneficial to install IPT servers in a same domain within AD or Voice ...
Hi All,Today the calls are getting dropped and when I looked the RTM Alert, I saw the below info, is it because of this that the calls are dropped.Calls are getting connected once in every 3 times only.Most Recent Alert Raised: At 16:47:49 on 06/01/2...
I have to configure a ccme with the following cards:VIC2-2BRI-NT/TE=VIC-4FXS/DID=How do i configure the settings for russia? I haven't found any info for configuring this interfaces according to the standards of Russia.
i have 2 callmanager server.each server for building and connect via internal trunk e1 with protocol q.sig.when i have dialing from 5xxx to 3xxx.the symptom was 3xxx can see calling name and calling number but 5xxx who was calling can see only dial n...
hiwhen using CAR for user reports-individual bill, department bill, or top N calls,.. and do view report an error message displays 30023: data is not available for the date range selected. Data is avaiable only from Jun 11, 2007 to Jun 27,2007. note...
Today I am having issues with my CCM sub and pub. All day phones have been unregistering from our sub to the pub and then back again. Now over the last few hrs one of our PRI gateways is doing the same thing. Also it is now starting to effect our cal...
When entering the login ID, is there a way to to shut off the alpha numeric option, I would be using just numeric User ID and PIN # ?Thanks in advance, Robert
I have CME4.1, no CUEOutside calls from FXO are forwarded to Operator Hunt Group.During work-hours no problem.I is possible, during off-hours, to redirect outside calls from FXO to TCLAA? or another Responder.Can it be automatically switched using ni...
Hello,I have the following field in the gkdefault.cfg file#txtupgradecode:3,0x601,0x0400,0x0100,192.168.10.250,0x060817A, 0x030829a,CP7912080003SCCP070409AI then have the gkdefault.cfg in flash and have the tftp-server flash:gkdefault.cfgi also have ...
We have specific number that rings into our PRI to one of our DID numbers about three or four times a week. When the person answers, no one is there. The user has asked if we can block that number since it's just and annoyance. I tried setting up ...
I want to create an account to read all users from LDAP server and the question is what prvilege required to do to configure in CCM 'LDAP manager distinguished name' field. e.g. administrator or domain admin or,,,,Advise pleaes,
Can you please tell me if we can use TAPS on CRS 4.0(1) server for a Callmanager 5.1 implimentation. The compatability matrix states that CRS 4.0(1) only goes up to CCM 4.3. Thus I realize Cisco/TAC woudln't support this setup for 5.1. But we only ...
