Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I am trying to make use of a POTS line connected to FXO port on 2851 for 911 calls going out of the router. I understand that dial-type, signaling type is important and I have checked that to be dtmf and loopstart respectively. Here is my configurati...
Hi;We use CM 4.1 and 2811 voice gateway. We have two FCTs. One is working properly, but another one has a problem(same vendor, same model, same config on 2811, H323 gateway).When the problematic number is called from outside, fxo port cannot transfer...
Hi all!Well, I have a 7961 phone with the 7914 expansion. I have configured an ephone-dn with "transfer-mode consult", and I have assigned it a button of the 7961.If I transfer a call with entering the complete number in the 7961?s keyboard, it works...
Hi.I was wondering is there any way to prevent the External Phone Number Mask to appear on the top-right part of the phone after it is configured in the DN page?Thank You,
Hi, I have a callmanager cluster. Pub in one site, and sub in another location each with one PRI. I have configure the gateway and route group but how do I configure the route patterns so when I dial out the call goes out using the local PRI and n...
Can someone give me some guides on how I can setup VoIp within our Company's network. I want to be able to connect all our branch offices back to our Headquarters offices and vice versa to be able to use our existing data network to carry voice traff...
I need your assistance in providing a document outlining the major diferences between CCM 5.1 and the new version 6.0.Thanks in advance
Hi allwe run a CM 4.2(3) with IP Phones 7960.We now ordered new phones 7961. If I have to replace an old 7960 phone is it possible to upgrade the phone to the new model (7961) or do I have to delete the old config and set up a new phone with model ty...
Gurus,I need to deploy a 7960 to a remote location behind a site-to-site VPN tunnel. I will need to manually set IP address, subnet mask, and gateway info to the phone.How can I do this?I'm running CCME.Thanks,-Michael
Sometimes the username on the telephone using Extension Mobility is blank. The telephone is used by one person all the time with Extension Mobility configured. We didn't restart the phone or the CallManager . Can someone help me how to slove this iss...
I have 2 MCS 7825 running IP IVR 4.5 separately. I want to change achitecture to HA mode. When I login Cisco ordering tool to order HA license (IPIVR-4X4Y-HA-UPG), the system shows the configuration error and need to order another MCS server. How can...
I've ordered Cisco NOK-SCCP-CCM-25= Nokia Intellisync PBX Connect for CCM (SCCP Client). Do I need software from Nokia for my Nokia E61 or only the Cisco Software.
i have hunt group login softkey configured on my 4.2 system. i cannot however find anything for the option of logging in or out of a hunt in either 5.0 or 5.1any pointers would be greatly appreciated
hii have DL-380 G5 HP server, as per CCM compatibility matrix (as i remember)these versions are from supported ones on this server 4.1, 4.2, and 5.1i have this question:1: if i got a CCM 4.1 version and wanted to install it on this hp server, will it...
Hi,?Can I forced to use an account codes in a CCME v4.0 and Call Detail Record (CDR) field entry to make a call?
