IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Hello!Everything worked fine for me, until I made a mistake in the dial plan: Instead of | 2_9 | I wrote ||2_9|, then I clicked on save.   Cisco hanging.   When I pick up the phone - the red diode does not light, when the button is clicked, the IVR d...

Hello,   Routing and switching guy with no insight into voice, need some assistance.   I need to have 8 polycom phones setup with PBX circuit on CME router which has CUE but does not have any configuration. All phones are setup with external carrier ...

I have a request to configure a call routing or flow as follows:   Inbound call from pstn arrives on PRI attached to Cisco IOS gateway.  The gateway is connected to Call Manager via SIP trunk.  The request is for the inbound call to a particular numb...