HICM4.1.3sr1Unity 4.0.5In SRST mode with inbound calls to the main site, can we configure the main sites to route inbound calls to the remote SRST site instead of going to voicemail.Thx
HIIf I have the following:Zone local Zone1 abc.comZone local Zone2 abc.comBandwidth interzone zone Zone2 128This means Zone2 is limit to 2 calls but Zone1 has unlimited because I didn't specify a "bandwidth" command right?Thx
Can someone review the attached sheet, and let me know if all the Route Patterns Look okay. Mexico is part of North America, and comes under NANP. Please let me know if I am missing something.Regards,
Hi there,Are there any ways to configure IOS(12.4) dial-peer setting(call to router from PSTN) when there is no called party number and no calling party number in Information Elements(ISDN BRI) from service provider? I tried as below,however did not ...
the page would not show up on 7940 even though it show perfectly ok on the emeulator i am using XmlTextWriter writer = new XmlTextWriter(Response.OutputStream, Encoding.ASCII); to output the xml filei been this for few days still not sure what's th...
Is there a distance limitation of an ATA from the analog device that is being attached to it?? in this case fax machines.ATA 188 V.3.1.0 sccpThanks in advance.
Does CCME support video through the Cisco VT Advantage product? I just received a couple of the camera's to play around with, but can not find any information on it.
Does somebody knows if CallManager support all the annunciator announcement through a SIP trunk. (For example "this number does not exist...").CCO states that annunciator can play ring through a SIP trunk during a blind transfer, but nothing else.Tha...
Does anyone know of a document that shows what phone loads are compatible with which version of CM?I just want to make sure that when I upgrade to 4.1 that I cause the forced reset of all my phones just to get the new load.
If I have 8 CallManagers and put 4 of them at a separate site will it take 900k per subscriber server over the link for database replication from the subcriber?
I have a failing nm-cue and have backed up the configuration/voice mail. I cannot figure out how to restore it to the replacement module. When I configure the backup through the CLI it tells me that there are no backups, though I have the history.l...
Hi allis it possible to change the "No Answer Ring Duration" on several lines using BAT? This parameters seems to be missing if I try to change it using the "update line" utillity in BAT...BAT version: 5.1(3)Cheers Patrick
AutoAttendant on CM 4.1, outside calls route to AutoAtt, caller has option of entering the ext. nr. of the party. Sometimes/someDNs it routes the call. Sometimes/someDNs the call drops, no announcement, no messages, no re-try. Just dies. On small sys...
