Other Collaboration Subjects

CCM 4.0. When I have an active call on Cisco IP phone 7905 or 1912 phones,and then I recieve the second call to the same phone. Then I can answer the second call while original call will be on hold. After finishing the second call there is no way of ...

In my current Nortel PBX I can tell a phone not to pick up an incomming ringing line (not Primary line) when going off hook. Instead i can default it to pick up the primary line and get dial tone (for an outgoing call). I do not want to pick up that ...

I know that this has come up in this forum before, but I'm hoping some kind soul can help me revisit this issue and get it solved.Microsoft's wsdl.exe tool (used to consume a WSDL file and generate a client proxy for the web service) errors out on AX...

Just recently installed service release 2 to bring our CallManager up to Cisco 4.0(2a) SR2. Ever since installing the service release, we cannot reset our phones using **#**. That was pretty handy as we didn't have to unplug the phones if we needed...

Hi,The customer has centerized call-processing with message system in head office,the voice gateway is AS5350 configured H323. My question is: is it possible for AS5350 to provide hardware transcoder resource? Thanks,JJ

Hi,CallManager 3.3(3), Cisco2811 4FXO configured with H323. In SRST mode, if I configured the blind-transfer for the inbound callers of PSTN, there is no problem on conversation. But if I configured the consult-transfer, then on the PSTN caller side,...

We are running CM 3.3(4) on 7825-800, 768MB RAM, about 150 registered phones. According to cisco 4.1 will run on 7825-800. Will there be any real life performance issues? The following services are not running: CDR insert, Extended functions, Voi...

I have a location where we are installing a CM 4.1(3), it has BAT 5.1(4) as plugin, which we installed. It seems fine, until we try to create a template, and it lets you get all the way through the process, until you try to finish - then the panel o...

I've got a 3660 connected to a Nortel Option 11c with a PRI. The 3660 is controlled by CallManager 4.01 using MGCP. We are using five digit extensions to make calls between CM and the PBX. Calls between the two are working fine.Problem is the PBX is ...

I am trying to get a softphone to work with a ccm 3.2 server. I have created a cti route point associated the user with the softphone but I do not get any lines to choose from when I launch the softphone. The trace says ciscotsp001.tsp| CSelsiusTSP...

Hello all. I am trying to get a Tenovis Integral 33 PBX connected via a QSIG PRI to a 2600 series router configured for MGCP against CCM 4.1(2). I am able to bring the trunk up and route calls across it, but when the connection is made, there is no...