Other Collaboration Subjects

I am trying to setup a 2610XM router as a mgcp gateway. We are using a T1-CAS for the pstn connection. I go under the controller t1 0/0 and issue the framing and line code commands with no problem. I am tryining to enter the command "ds0-group 1 t...

I intermittently get the following in the event log of the Publisher,the files get left in the BAD directory. when I go to the CDR directoery I see the files coming in and getting cleared, so most of the time the cdr insert is working( I see the data...

I have an unusual problem. I am running CCM 4.0(2a)SR1 and a gateway router 2821 12.3.11XL.I have a 2 port multiflex card which are MGCP controlled. Both of ports have a PRI connected and both work fine. My problem is that whenever I make a change...

Iwont to abtai a certification from cisco about telecomunicacion industry

Hi AllI would like to redirect calls from a voip peer to an alternate local CCME number, when the destination network is down. Can this be done?Thanks

Hi all, Setup is as follows.ccm 4.1 2651xm as an MGCP qsig g/w, through a westell iq2000+ convertor to dpnss to a siemens PBX.Previously had this working as q.931 and when an ip phone diverted to voicemail, (seperate vm, hanging of dpnss network), us...

Hi!I set up CallManager express with H.323 VoIP connection to provider (public telephone networks). I need to deploy auto-attendant feature, its_Cisco.2.0.1.0.tcl script. I linked this application to my incoming VoIP dialpeer but it doesn't work. May...

Hello,I just configured a CCM 4.1(2) cluster from scratch.When i try to add a new phone, the mandatory Owner User Id field fails with the Popup window:Microsoft Internet ExplorerThe login ID entered is not a valid ID.I think it could be caused by som...

Hallo I am new to CISCO IP PHONES so i'd like to askif anybody know how i can configure passwords in my IP PHONES(7912-7940)??Is it possible to ask the IP PHONE fro the user a pin number or password to let you make a call??Thank you for your time.Xza...

Folks. When You dial to some extension and it reaches the voice mail you can diual an extension during the greeting in order to try to transfer the call to any other subscriber. But after dialing the extension you heard a message from the system sa...

How many of you have, with little issue, run VoIP over Cisco 1310 wireless bridges with no other transport in a centralized CM design?

I need to change the TFTP address on the phone but the settings are locked. I tried **# before the settings menu but it does not work. I plugged in the phone it found the DHCP server OK but it is stuck on Configuring IP message.Are there any other co...