Other Data Center Subjects

Hi, I would like to configure HSRP for 4 routers, 2 N5624Q in a vPC pair and 2 other 5624Q in another vPC pair.   How can I do that ?   I use the same group of course, but do I need to do a different configuration or I do as if it was 4 independant s...

Hi,   How I can configure Cisco Prime 3.3 for all devices auto config backup for example every evening of Thursday and upon completion or not complete or error, I shall receive email notification. Please help its urgent. need steps for configuration....

May i know why the show forwarding route show "null0" for next hop? though show routing shows "172.22.22.1' as next hop. 172.22.22.1 is in the global routing table. whereas 192.168.200.20 is in VRF-1.   LAB3XSW0055-VDC-CDOQ-Golf-2-Chassis-1# show rou...

Hi all,How to we calculate the equipment cooling for the Nexus 5000 and Nexus 2000 series switches in kW?I have seen the Cisco Power Calculator but it doesn't have Nexus 5000 and 2000. Also the heat disspation is in BTU/Hr rather than watts which is ...

Hi guys. I hope on the correct Forum area here.I want to ask about Dell Twinax Cable. Can Dell Twinax Cable with Product Number V15WR used for connection between Nexus 7000, 5000 or 2000 ?If it can or can't, I hope somebody can give me a link to docu...

Hello all; I see on the N9k that I can configure PBR as below set {ip | ipv6} next-hop address1 [address2...] [load-share] Cisco stated in the documentation ""You can optionally configure this command for next-hop addresses to load balance traffic fo...

 Nexus 9300 switches are not loading with code  and getting the below error. Loader> prompt and i tried with boot command and no luck. Do we need crossover cable for netboot from tftp server?Configured the IP setting in the nexus through Set command....

Hi,1. Is it possible to have a mix of FAB-1 and FAB-2 modules on the same Nexus 7000 chassis at the same time? Is this supported?2. What about backward compatibility with FAB-1 supported I/O modules? For example, N7K-M132XP-12. Will this card work wi...

I am looking for solution for connecting 2 server sites over L2 stretch that can be done on lower end hardware. OTV seems to be big iron solution. Suggestions?

Hi,We have two Nexus 5000 in HA configuration that use a switch port profile to share configuration changes.Earlier this morning the secondary switch rebooted (this has happened before).Just prior to the reboot the syslog server received the followin...