Other Network Architecture Subjects

I have 2 T1s between location A and B. Location A has one 3620 router (R1) and location B has 2 7206s (R2 and R3), with one T1 going to each. The 2 routers in loc B are connected via FE ports to the same switch. I am using OSPF.R2 is sending data des...

Hi, Everyone I just been awarded the responsibility of installing 4 3745 Cisco routers. The local phone company wanted $5500 dollars for the installation and my employer thinks is to much. I was looking at the Cisco website for sample configurations ...

HI all.I use an ISDN cisco for dialing in ms win98 remote access client with chapas authenticate.All works correctly, i assign dinamically the ip to all clients that connect,but the clients does not take the correct default route to my isdn router.Wh...

I had problem with 3620 router w/z 24MICA modem and PRI/CSU(2 T1) module. When I look at "show isdn status", Layer1 was showing "Deactivated", so I check with our carrier(teleco) but they told us PRI line seems no problem.After I tried several fixs ...

We currently have two ways of getting out to the Internet from my location. I have other buildings that come through my location to also get to the Internet. We are trying to point all Internet users to go through the new connection where only traf...

Hi,I have a WAN which consists of two locations, 3640's at each end, connected via Point to Point T1. I just installed a 9 mile wireless transparent bridge link between the two locations. Question, would it be better to by-pass the3640 and plug the w...

Our network currenlty connects to the internet via a 512 fractional T1 through a Cisco 1720 router. We also have 3 isdn lines in house that are used exclusively for video-conferencing. The ISDN lines connect to an ADTRAN NT1 (4 ports) which then conn...

hello,i am having a problem acquiring users on 3512xl switches. i have had ciscoworks obtain users from a couple of 3512's on our network but the rest aren't being picked up. the devices are shown in rme and i have also tried doing a discovery specif...

I am trying to configure MRTG to give me data about utilization on my wireless network. When it's configuration script looked at my radios through SNMP it found some interfaces that I'm not real sure of their translation to the physical world.I've g...

I am running a 3640 at a co-location facility. It is running Version 12.2(5a), RELEASE SOFTWARE (fc1). How do I tell what the port speed of the interface is set to? I've printed out the config, and it just tells me that it's full duplex. I did a "sh ...

Hello all,quick question about proper code for the following configurationCatalyst 5509SUP III GDo I use the SUP III code or the SUP G code?Also, how do I see the name of the actual code that has been uploaded to this switch. The show flash and show...

I am looking at replacing our 10 Base T network with a 100MB switch solution.Can anyone recommend a reliable switch. At the moment I am just looking for a 24 port 10/ 100 MB switch - nothing too fancyMy main concerns would be ease of installation, ge...

I have two 3640 router running eigrp between them. I want to enable "log eigrp neighbor changes" on both router. What do i need to do to send eigrp loggging messages to my syslog server. This is what i did so far on both routerlogging 10.x.x.x (Sys...