Other Network Architecture Subjects

Dear all,i want to delete html folder in 2924 switch. it's failed. please help! Thanks!Samuel=======================================Cat1(config)#no ip http serverCat1(config)#endCat1#00:33:57: %SYS-5-CONFIG_I: Configured from console by consoleCat1#s...

I'm not sure if this is possible, but I have a development group that has asked that their dev machines be assigned addresses from a certain subnet, a subnet that is different than the one assigned to the router's fa 0/0 int. Normally I would say th...

1. Can a trunk port be source of a span ot rspan session. 2. I have an 802.1q trunk and ISL trunk ports in an a single ether channel. What i ment is can i ahve different trunking encaplulations in an ehter channel.Thanx

I have a 6500 Sup2/MSFC2 running in hybrid. The Sup boots up correctly however when I "switch console" to MSFC, it was in ROMMON mode. I did a "reset". it showed unable to find the specified image file, and stayed in ROMMON. Then I did "dir bootflash...

we have a wired guest network in back of our BBSM in our main building. I am trying to extend this network to other buildings by using gre tunnels. The hub is a 6500 and the spokes will be 4707. The tunnel config is easy and came up fine I am using k...

MaadenRIY#sh ip cef exact-route xxxxx.196.129 172.31.1.50xxxxx.196.129 -> 172.31.1.50 : Serial1/3.1 (attached)What attached means?what is the benefit of using CEF on Router. is it any advantages for router?

I tried to configure ip address on an ESW interface and got this message: % IP addresses may not be configured on L2 links. Is there a work around this? How do i get to use this interface.

Hi all, when people create an internet vlan, is this used for people browsing the web and they dont see any other parts on the local lan, or are they for servers etc which are shared on the web ?

dear all,i have a 1841 with 12.4 base ios.in that i had installed a wic-it card and connected a leased for internet, public ip's are configured and its working fine.fa0/0 is also configured with public ip.in routers 2nd slot i installed wic1 adsl car...

I have a 3550 connected to a 3Com switch used to offload non-PoE devices and save ports on the 3550. Connected to the 3Com are 2 ATA 186s. The ATA's only run at half-duplex, and are working fine, but as the 3Com attaches to the 3550 on full-duplex,...

HI,I have a question here.I have serial 64k and a backup ISDN2 tat dials to ISDN30 PRI Interface at Headquater if any problems happen to serial interface..Question is Can i limit the 64k at the BRI interface as I wanna make sure it is the same as the...

Hello, I'm trying to connect a 3550 to a 3524XL switch. I have a crossover cable but I still have a down/down state on both ports. If I plug the cord into 2 ports on the 3550 it works. If I plug it into 2 ports on the 3524xl nothing happens. WHen...

HiI keep losing connectivity to the management IP address on 2950 switches, although all other VLANs continue to work through it.When I plug in a console connection, loads of buffered messages are output (just port up/down messages), and then IP star...