Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, Src Srv ---Core switch (sparse;RP) --- Multiple Border routers(for mpls, p2p,isdn) ; (static joing group.x.x.x.x )-----------isp-------------client end router-----client lan ---receiving feed anent. Abover mentioned is generic multicast scenari...

s4sandyad by Level 1
  • 837 Views
  • 2 replies
  • 0 Helpful votes

Hello All, I have configured the below autocommad menu for a customer as below menu alge_menu title ^CC******************Test****************** * ** ** Telnet Menu ** * * *******************************************^Cmenu alge_menu text 1 show inte...

ranjit123 by Level 3
  • 1108 Views
  • 3 replies
  • 0 Helpful votes

Greetings! Thanks for the help in advance. I have a situation where the SLA target I want to test against to control a route insertion (redistribution via eigrp) will start to succeed when traffic is redirected via an alternate path. Consider the ...

I'm working on an NBAR based QoS marking solution for my enterprise.  I have several 4351's and some 4451-X routers.  When I run the command 'show ip nbar protocol-id' on a 4351 I see over 1300 apps.  When I run the same command on the 4451-X I only ...

hypnotoad by Level 3
  • 630 Views
  • 3 replies
  • 0 Helpful votes

Resolved! NIM_ES,2-4

Hi all, I have a cisco 4321 router and I am trying to add NIM_ES,2-4 but is shows offline as per the errors attached is there something i am missing?

Hello folks, I was wondering why if the DHCP snooping feature is enabled on Sw1, the port 3 on Sw1 must be configured as "trusted port" ? R1 is DHCP server, R3 is DHCP relay agent (ip helper-address is configured on f0/1), R5 act as client. Assuming ...

DuJin0509 by Level 1
  • 14999 Views
  • 10 replies
  • 0 Helpful votes

Hello Everyone,  I just tried to setup HSRP Load sharing in Cisco Packet Tracer.  I have allowed VLAN 10 to go through Router R1 and VLAN 20 to go through R2. Have Setup HSRP Group 10 and 20 on both Router.  R1 configured as primary for Group 10 t...

Rizwan by Level 1
  • 529 Views
  • 1 replies
  • 0 Helpful votes

We have 2 WAN circuits that we configured as active and standby. At the edge we are using HSRP and it is tracking the active primary circuit so if the active circuit fails, HSRP decrements the priority and therefore secondary circuit takes over. But ...

cofee by Level 5
  • 665 Views
  • 4 replies
  • 0 Helpful votes

Greetings. We have recently signed up for Metro Ethernet for our main campus and 8 branches. It's a "mesh" with the carrier providing a virtual layer-2 switch in the cloud. I have a router at each site running EIGRP and they all have neighbor relatio...

m.glosson by Level 1
  • 1148 Views
  • 2 replies
  • 0 Helpful votes

Hey Guys, Can someone please explain how ECMP groups works ? What will be command to check utilization or number of ECMP groups being used may be nexus 5k/3k/7k or any other platform specific. Let's take a example of  spine leaf Architecture from lea...