Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear Sir,I have some question about status when am use command : sh ip bgp sum-- sh ip bgp sum --<neighbor IP>  4        <neighbor as>      10   21914        1    0  599 00:06:19        1 (SE)-------------------------reference ..The S,P,E output is d...

hatman by Level 1
  • 11877 Views
  • 0 replies
  • 0 Helpful votes

Hi all, I would connect a VSS system with 2 upstream device which are remotely located (15 km and 600km).The idea is to build 2 MECs (from the VSS to each site) and to configure 1 p2p on each MEC. The links forming the MEC don't necessarily follow th...

Helo all,I have a scenarion. Im just beginner to BGP. We having customer with total 16 sites, 2 HQ and 14 branches. all this sites connected via MPLS which running under BGP. The MPLS cloud managed by our ISP. 2 HQ router which connected to Telco UPE...

There are many links between two eigrp routers. A feature called single peering over parallel links could implement that only one neighbor relationship exists no matter how many links between the routersBut I don't know which command I need to implem...

Hello experts,Core: DC  : 2- 6500 (PO Trunked) Configured L3 vlan interrfaces with HSRP.Vlans:Servers - 192.168.5.0/24PCs: 192.168.10.0/24Phones : 192.168.20.0/24Replica-exchange: 192.168.30.0/24--------------------------------------DR- One Core SW:V...

I am configuring my DS-3 and can't seem to get it to come online. My SP is telling me the circuit is online and ready to go.When I do a sh controllers T3 here is what see: T3 1/0 is downApplique type is Subrate T3Transmitter is sending remote alarmRe...

ddevecka by Level 1
  • 1911 Views
  • 11 replies
  • 0 Helpful votes

Hi,Sorry if my question dummy.I'm going to upgrade rommon image,according tohttp://www.cisco.com/en/US/partner/docs/ios_xr_sw/iosxr_r3.2/getting_started/installation/guide/gs32arup.html#wp1016692Link "http://www.cisco.com/cgi-bin/tablebuild.pl/crs1ro...

D_Lebedev by Level 3
  • 393 Views
  • 1 replies
  • 0 Helpful votes

Hello,I have a problem with my router ASR1006, come the following errors in the log, I could say it means.Dec  9 17:50:11: %QFPOOR-4-LOWRSRC_PERCENT: F0: cpp_ha:  QFP 0 IRAM resource low - 98 percent depleted Dec  9 17:50:22: %CPPOSLIB-3-ERROR_NOTIFY...

Hello i have a couple of 3925E routers running HSRP both internaly and externaly. I cant get them to NAT the traffic though. They just route it out. I also tried to connect via VPN to se if that worked and it didnt. Im poundering where im going wrong...

I have a design issue.  I need to route traffic to two different ISPs using one router.  We have two ISPs and I need to route important traffic over one and recreational traffic over the other.  My thoughts were to have an 1811 router connected to th...