Routing

Hi,We have 2 ISP and we've tried configuring backup between them.we used :ip route 0.0.0.0 0.0.0.0 gw_isp1ip route 0.0.0.0 0.0.0.0 gw_isp2 10.we tested it by shuting down the interface or unplugging the cable.It works fine.The problem is that we have...

Hican u you help me for the BOQ for the cisco 3460 routerWhich IOS is best How Much flash ?? [16 MB]How much Nvram ???[48 MB]And which network module is best for E1's. minimum and maximum E1 suppotsBest regards

I have a Cisco 2620 router and need to configure it. I already have a WIC T1 card in the router and the T1 implemented. Can anyone provide guidance on how to go about setting up this router?Thanks,Jerry

here is the debug of Q93100:06:53: ISDN BR0/0: TX -> SETUP pd = 8 callref = 0x2A00:06:53: Bearer Capability i = 0x889000:06:53: Channel ID i = 0x8300:06:53: Called Party Number i = 0x80, '17348017', Plan:Unknown, Type:Unknown...

Hi,I have implemented 2 classes using CBWFQ, one is default class and other scavenger class (CS1). The CS1 class is being used to control a centralised email system from impacting on all other WAN applications. There are many different sized WAN link...

could any one tell abt the access list in the routers

Hiplz cck also the attached network PIc,I have to provide bandwidth to the Customer router of 2 MB.Router-A is our core router(BGP running).Router-B is edge router("static routing" we are using it for our provate network).Customer router need 2MB Plz...

Hi,When using CBWFQ on an ATM pvc the maximum bandwidth I can allocate to all classes is 75%. Does this mean the other 25% can never be accessed/used by user data? I assume this limit is there to allow for the ATM cell overheads!Thanks in anticipatio...

Dear Sir,i have 7600 router with WS-X6408A-GBIC so i want to know if i can use WS-G5483 (Copper Cisco 1000BASE-T) on the WS-X6408A-GBIC to connect 10/100 interface RJ-45so i want to know that the WS-X6408A-GBIC will work as 10/100 or only it work as ...

Hi,The client(Client A) router is configured withinterface FastEthernet0 ip address 172.20.96.2 255.255.240.0On my router(3600) I am advertising 172.20.96.0 /20 and I am routing it back to the client via the interface(s1/0) they connect to on my rout...

It has been recommended to me to converge my internal network and public Internet into a single 6509 switch with FWSM. I was told to do it with VLANS and that it would have line speed performance. How can this be done?

Hi,Please find the attached topology. The question here is1.Will this work with out area0?2.If it works will R1 lear about the route of R5?3.What does the R3 called as ? will it be ABR?Thanks in advanceRegards,Senthil

Is there any advantage to using OSPF or EIGRP for your internal routing protocol when using MPLS?

I have a hub site which was part of an aquisition, but is now completely trsuted. They have a linux firewall with 192.168.0.x LAN addresses, but are all 1 to 1 static natted to 10.161.0.x addresses. I need to figure out how to remove the linux fw w...