Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hello community, After quite some research, I have not concluded to which is the best practice in terms of configuring Cisco switchports to IP Phones. Two options: Option #1: Switch(config-if)#switchport mode access Switch(config-if)#switchport acces...

alfista16 by Level 1
  • 7343 Views
  • 13 replies
  • 0 Helpful votes

Hi, I have 8 switchs SG200-26. I have one network (192.168.8.0/22). My gatewate is 192.168.10.1. Could I configure one VLAN for each port of switch, and port of my gateway could I untagged for response all other ports? My intension is block all acess...

Samuca by Level 1
  • 956 Views
  • 2 replies
  • 0 Helpful votes

I am trying to see HTTP connections from 2 devices both on the same subnet. One device can access another totally fine & there are no communication issues but when I run the captures below I dont see anything show up on the capture. I double checked ...

Catalyst 2960-X switches running Version 15.2(3r)E1 Trying to track down why some devices are connected at 100mb instead of 1gb, like they should. So started using "test cable-diagnostics tdr interface gi1/0/1" When device is plugged in, showing up/...

joebrug by Level 1
  • 6471 Views
  • 4 replies
  • 0 Helpful votes

I have a 4331 ISR connected to a 2960 stack switch pair. Port 0/0/0 is the WAN port, and 0/0/1 is LAN connected to the switch. Initially I had thought to use NIM-ES2-4 card to create etherchannel to the stack switch pair. However the NIM-ES2 card doe...

I work at a university and we are using non-cisco controllerless APs in our dorms. The dorm switches are mostly 3750x but we have some old 3560G as well. Here's how an AP port is programmed on both models:   interface GigabitEthernet1/0/1 descriptio...

jgroves by Level 1
  • 3298 Views
  • 5 replies
  • 0 Helpful votes

QoS

Hi, We are about to implement 300 devices that will be using Voip. I have a general understanding of QoS and traffic shaping, but was looking more for real world advice as where to begin. 

toolshed1 by Level 1
  • 659 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card