Switching

This message comes up when trying to do copy to startup-config on Cisco 7604 router with SUP32 module.The problem became worse and worse and later customer could not even do a show log show run or show startup. All these commands would just return to...

I have a two routers connected via a crossed cable (3700 and 2800) the configured with /30 ip addresses. this setup worked till yesterday then stopped. What could be the issue:1. show cdp neigbors is showing the other router on the connecting interf...

Hiin my LAN i have two 4503(distribution) and 10 switch (access).I applied this VACL on two 4500.This was worked well.vlan access-map Guest-wifi 10 action drop match ip address deny-guest-wifivlan access-map Guest-wifi 20 action forward!vlan filter G...

%OSPF-4-FLOOD_WAR: Process 100 re-originates LSA ID 202.179.111.69 type-2 adv-rtr 202.151.240.40 in area 0I have read a few forum entries saying look for duplicate Router-ID.Should I look for a duplicate 202.179.111.69 addressor202.151.240.40 address...

Is it possible to have multiple vlans in single port? Current configuration what i have is "switchport access vlan2" which means if a vlan3 users wanted to connect on this same port, I will have change the configuration as "switchport access vlan3" e...

Hi,I have a 3560Switch which boots but gives orange LED on SYST & RPS.Is this an hardware issue or software being corrupted. Details of switch on the attachment.

hi,i have problem with Switch 2960 TT . There is Port err-disabled and Link is down.when we do shut no shut just one up and again link is down . and port indicate err-disabled.??/ so what i will do ...>?

Helo Gurus,What ios version to support crypto?Thanks.

Whate exactly are those "uplinks" on the RSP 720s used for? Its a bit strange.Can they be used as regular data ports, as in any other SUP module, or do they have a specific and limited use? Is it just for management?Do you HAVE to configure them with...

Hi, folks:Here's the question...There are 2 routers in a VRRP group...The active router is tracking an object...The object fails...The active router decrements its priority by 20 (configurable, I know)Backup routr becomes primary...The tracked object...

Hello All, I'am trying to come up with the best method to load balance RTP traffic over two 1.5 mb ATM links. Currently CEF is load balancing via source and destination ip, since the RTP traffic is between two PBX's the traffic always takes th...