Switching

I have routers with very many static routes, many of which I suspect are no longer needed. Is there some command that will show the number of matches for each "ip route" statement? cf. show access-list for matches of ACLs. Does anybody know any othe...

I have two networks,Physicallyconnected .I.e;192.168.0.0 &192.168.1.0,How the communication possible between 2 networks.Where to configure routing.

I'm a bit of a Cisco newbie and I'm hoping someone can offer me a little assistance. I have a Cisco 851W which I have configured using SDM express. Everything is working fine with the device, with one exception. I am apparently only able to open cert...

pls look at diagram attached. Router A and B are branch routers. B is PIM DR on the LAN becuase it has higher IP 10.36.200.3. There is only sparse-mode running and RP is WAN2 across the WAN links. 1. Normally, multicast tree is built from router B to...

hi; can I use Cisco gbic in Juniper netwscreen slots?

Hi All,I am facing a high CPU utilization on my Cisco Catalyst 2924-XL switch, although i did "wr erase" and reloaded the switch."CPU utilization for five seconds: 30%/6%; one minute: 30%; five minutes: 30%"Port Status Proc --> 11%LED Control Proc --...

Hi All, I have just upgraded from 12.1(14)EA1 to 12.2(35)SE. Now, the bootloader in IOS 12.1(14)EA1 was 12.1(11r)AX. The technote for the latest IOS 12.2(35)SE states the bootloader will be upgraded. It has not in my case, it remains at 12.1(11r)AX...

How do I located a node on the network by just the IP? I would like to know which switch it is connected to.

Does anyone know what would cause this?73498724 packets output, 230458162 bytes, 10032 underruns0 output errors, 0 collisions, 0 interface resets0 babbles, 0 late collision, 0 deferred0 lost carrier, 0 no carrier, 0 PAUSE output10032 output buffer fa...

I surprisingly didn't find much documentation about port range forwarding.I would need to forward a few ports on my 877w, and I might have seen a solution between two static addresses. However, although my provider gives me a fixed ip address, I get ...

Anyone any ideas on how to force a IOS switch (cat 3750) to only use SSH ver 2 ?ThanksMike

Hi All,How to find out my Switch is having CATOS or IOS ? 5 Ethernet Ports in one module are not working.Rest of the ports are working fine. Any workaround ?