Activity in Technology and Support
FTD API on FMC managed device
Hi,Is the FTD API available when the device is centrally managed by FMC or in this scenario we must rely on the FMC API only?Regards.
Firmware for SG 200-26P
Hello everyone,I'm new in here and just found out that the above mentioned switch is no longer supported by Cisco. This also means that I can't download firmware versions which are newer than mine (1.0.0.19). Anybody here who can help me out with new...
Cisco ISR1100 Software viptela 20.9.4 upgrade software IOS XE
hello everyone,have a nice dayI am buying a cisco ISR1100-4GLTEGB device but when I turn it on, it is running the firmware viptela 20.9.4vedge# show version20.9.4But my customer wants this device to run on IOS XE firmware and gave me a firmware isr11...
AAR Traffic
I recently started managing Cisco SD-WAN and I'm currently exploring the Application-Aware Routing (AAR) feature. I’ve observed that centralized policies are already applied, and I'm interested in gaining more visibility into the traffic governed by ...
Viewing SSH local Destination IP for authentication attempts
Hi folks,Raising within this community board because it had the most hits for SSH questions,I have a number of "%SEC_LOGIN-4-LOGIN_FAILED" failed SSH authentication attempts which I've tracked down to being a scanning-type behaviour from a customer's...
Set OMP Route Preferences Locally
Hey All, As far as I can see, there is no way to set OMP preferences via local policy. The idea here is to backhaul internet traffic via one of two data centers in the overlay via service VPN. I want to be able to set one data center primary and the ...
Implementing Remote Access VPN in Secure Firewall in Evaluation Mode
Hello everyone, I would like to know if it is possible to implement Remote Access VPN on Cisco Secure Firewall while running in Evaluation Mode? I have already completed all the required configuration steps and enabled IPsec/IKEv2 with the DES algori...
Resolved! Help verifying SD-WAN OMP routing from CLI
Does anyone know if there is a CLI equivalent to show ip cef for doing an SD-WAN/OMP lookup?I'm looking for a command that will fully resolve the OMP learned destination to the local IPsec tunnels, showing the full recursive lookup.In the attached sc...
VOIP
Hey, everybody.how many ip phones can be connected?I need more than 70 phones, but only 40 of them accept addresses.and the router gives an error%IPPHONE-6-REG_ALARM: 24: Name=SEP001D452D50BD Load= SCCP41.8-3-3-3SR2S Last=Phone-Reg-Rej %DHCPD-4-PING_...
Block Inter-Client VPN Traffic in Cisco ASA
Hello,I want to block the traffic between hosts in the 10.120.0.0/24 network at Layer 2.For example, on my Cisco ASA I have a VPN pool configured from 10.120.0.0/24 and users are connecting with these IP addresses.In the logs I see entries like:Teard...
Cat 9500-series MTU change and port-channels
Device models C9500-32QC and C9500-24Y4C running code 17.12.4 or 17.15.4. Changing system MTU results ports in LACP going down briefly. Is this expected behaviour?
How to allow return traffic of ACL?
Hi, I have created a simple network diagram by using Cisco Packet Tracer. Here, I want to deny all the access from "Network 2" side to "Network 1". At the same time, I should be able to access the devices of "Network 2" from "Network 1".I tried with ...
CUCM Upgrade from 14 - 15 Outage Periods.
Hi Looking for some real work advice on an upcoming upgrade from version 14 - 15 on my CUCM cluster. In the past we have been able to complete direct upgrades but this time we will have to use one of the following. PCD Migration Task Fresh Install...
SSM OnPrem - bug CSCwr45134
Hello, We have problem with Network Synchronization between On-Prem account and CSSM account. The result of sync is this error message I found on Cisco Bug Search Tooll, that this behavior is already reported as bug CSCwr45134. As workaround is "App...
ASA stops forwarding traffic
Hi allWe have a pair of ASA5516-X devices, running as an active/standby pair. Several times a day, the active device will stop forwarding traffic so all users lose connectivity to all data, applications and services. There is no error message in the ...
| User | Helpful Count |
|---|---|
| 119 | |
| 102 | |
| 68 | |
| 61 | |
| 60 |
