Unified Communications Infrastructure

Hi All,I have a CUCM 8.6 which was upgraded from CM 4.1 to CUCM 8.6 about few months ago by another colleague of mine. The person has left the company, and the CUCM 8.6 has not come up into the production network.Between that time till now, there has...

I have more info so I figured I create a new thread.I have a client with a single 9951 SIP phone connecting to a 8.6.1 CUCM BE server.  Prior to upgrading to CUCM 8.6.1, the same phone and firmware version was registered to a CUCM 8.5.1 server and al...

I have a scenario where the client wants everyone to have to enter their ID followed by their PIN to log in to their voicemail box.  This has been working great for the last 4 months.  Suddenly we are getting calls where users are only asked for thei...

Does anyone have any idea why I keep getting warnings such as the one below? I have checked all of the restriction tables but everything looks good. Any ideas?Event Type: WarningEvent Source: CiscoUnity_ConvSubEvent Category: (14)Event ID: 1155Date...

Hello all,Iam doing a new installation for Unity 8 without Failover with Exchange 2010 as a partner server.I had done the OS Installation,done all latest Server updates, latest ES patched, had run the ExchangeMapiCdo.EXE. I had completed the Permissi...

                   I'm having an issue both servers in the Cisco Unity Connection cluster have Primary server status. i have rebooted bother server still same resultany idea?

TEHO Calls via Gatekeeper Faisal KhanVoiceBootcamp Inc

We are running CUCM 7.1 we are using an external conference bridge and would like to be able to route a call and out pluse the conf code.Example: route call to +7770000020,,,294xxxx# to enter the confIs this possibe?

I have a customer using cucm 8.5, this person wants to change the speed dials of her colleague from her ccmuser login.She can pick the device profile ok from her ccmuser page but when she attempts to change the speeddials she gets a message "( X ) Ad...

                   Hi, I'm going to change the IP addresses of ADs integrated with our CUCM and all forests and credentials are going to remain same.once i change the IPs in CUCM..how can i verify if the Sync and Auth are working properly and is ther...

Hi,I have a Cisco CME runing on an ISR 2821 with 2 pstn lines setup for outgoing calls. I want to add the appropriate command lines so that the calls can be balanced between the 2 lines: outgoing calls should go once through the 1st line and once thr...