I have cisco meeting place express. The problem is when the user makes out dialing from meeting place express, calls are going through. and MPE Prompt "input 1 enjoy the meeting. input 2 stop call me. ". when user input 1, But meeting place express i...
Hi,I wanted to configure a domain name for "cisco unified communication manager 6.0.1", which is currently assigned with an IP address.I request to inform me, the details required for configuring a domain name to CiscoUCM instead of IP Address.Curren...
I am trying to install schema on the schema master and getting the attached error, all registry settings are in place and remote registry services have been started as well, has anyone else ran into this problem?
Hi,I have a Presence Server 6 installed with a CallManager 6 publisher node. For some reasons, I changed the IP address of the CallManager. Everything worked great until I restarted the CUPS. It can't make an AXL connection with the CCM because it tr...
Hi allWe have recently upgraded to CUCM 7.0(1) and CUPS 7.0(2) (only 1 CUPS Server Node). Everything works for existing users that were configured in CUPS 6.0 before the upgrade. The existing users were automatically assigned to the CUPSubcluster and...
guyswhen we access email from the phone and delete, it is permanently deleted. is it possible to block this or have it moved to the deleted items folder instead of permanent deletion?using exchange 2007thanks in advance
I have a requirement to setup TTY for external Hearing Impaired clients. I read the languages section in Unity and to setup TTY it said to install ENX language pack. How do I do that? I have 3 supported languages, do I have to get the CD's again a...
we have unity 5.x on box failover, all config replicates from primary active to secondary inactive except loaded languages - make a change on either phone or gui language on primary and it does not replicate???
I dont get the CP-521 phone to register to my UC500. I have the 12.4.11-XW9 IOS and there is a .bin file which I have put as tftp-server, but what about the load statement under telephony-service, what should I specify as load for the 521 phone?
Guys,I am failry new to Cisco CallManager. I have Cisco Callmanager 4.1 with 10 7960/7970 phones. I have a 2600 voice gateway with FXO and FXS ports on it. I have a normal phone line which I have connected to the FXO port and analog phones connected ...
In preparing for the holidays, we are setting up alternate greetings on our call handlers as usual. However, we are struck by the fact that there is no expiration on the call handler alternate greeting like there is on personal mailboxes. Any ideas...
Guys,I am having problems installing CUCM6 on a HP DL380(G5) with below spec. HP DL380(G5) 3.3GHz/1333MHz 6MB L22GB RAM300GB HDD Space on Raid 5The install fails with the below message:Critical Error:The Hardware you are using is not supported for th...
Failover 5.01 on box vm - we were experiencing CSCsc86904 on both servers i.e could not open sa page with ie. Only way round this was either reboot or restart the www service. Done the timeout session settings on the secondary and primary servers in...
