Voice Systems and Accessories - Small Business

We have recently set up MeetMe conferencing and have encountered the following issue...The first participant to enter the MeetMe conference extension in greeted with dead air.  It isn’t clear if you just got cut off, or if you are successfully entere...

HI,we are a small business and hence no full time IT support.We bought our UC560 with some 7900 phones for inhouse use and SPA525G2 for our remote sales people. SPA phones firmware 7.4.6 needs to be updated. I was told by a cisco expert that the new ...

HelloI have UC560 with 2 vic cards for 2 T1, and the configuration that I need is this:The long distance call has to go for the First T1Local calls for the second T1and also I need a failover, If one of the T1 fails used the another one.Any help plea...

Hi,Please could someone tell me if Cisco Mobile and Jabber are compatible with the UC560 ? and if so are there special requirements ?Any help will be much appreicated.Thank youJoshua Royle

I have a few SPA252G that connects via VPN, but everytime they make a call it only last about 4 to 5 minutes sometimes less then it drops, basically the connection is lost and the phones reset, how do I check on the UC560 to see why the connection wi...

Hi all,Firstly, let me apologize for my ignoreance in all matters Cisco - I'm slowly learning!For some reason recently when I reconfigured our UC540 via the CCA (created a additional VLAN with DHCP, disabled DHCP on the DATA VLAN), I am now no longer...

Good Morning,It appears that UC320's are being shipped with older firmware applied on them, and as a result we are having difficulty logging into them using the latest versions of IE;Firefox and Google Chrome. Although I havent tried Safari I imagine...

My PAP2T works with YouMagic SIP Service (http://www.youmagic.com/index.php?lang=en)It displays wrong Caller ID - it displays MY number (+7499709xxxx) not calling party number (+7916xxxxxxx)Wiresharked INVITE request INVITE sip:7499709xxxx@a.b.c.d:34...

Hi,I'm having issue with SPA8000 daylight settingsegusing this parameters for NSW timezone (used in other SPA units eg SPA900, 500 series etc)<Time_Zone ua="na">GMT+10:00</Time_Zone><Daylight_Saving_Time_Enable ua="na">Yes</Daylight_Saving_Time_Enabl...

We need to able to select a range of ports when configuring a Port Forward on a UC320 install. Using a "-" between ports is not available for use. Anybody know of a way of doing this?ThanksCarlos Bermudez

Hello,One month ago, I start using my UC540 with a Voice Ip carrier to do some tests. The carrier is Vozelia in spain.After configuring the trunk it starts working finde, making and receiving calls.One week ago inbound calls start failing. I told the...