Hello Friend'sI really need help for this problemSometimes the client of WIFI it connect to Internet and sometimes it cannot connect to Internetand when the client cannot connect to Internet from WLC 5520 CLI I cannot ping the DNS Server but sometime...
A test is in progress. In flexconnect environment, ping from client to WLC is not possible.IP is accepted well and wireless can be used without problem. In my opinion, I think ping should be done through WLC even in flexconnect mode. tell me your opi...
HiI'm testing iPSK with ISE. I can get it working on a single controller. Depending on the device and the endpoint group it's in I assign a PSK and a vlan and it works fine. Now I want to do the same but with an anchor controller.From doing anchor...
HiHow do i convert a 9164 to DNA Mode, is it the same as converting from DNA Mode to Meraki Mode?KR Christian Josiassen
I just created a pka file but when connecting the mobile device to the 3702i access point, the device does not receive a DHCP IP address. Can anyone give me the solution. Thanks for all your helping
Hello Team, I need any Cisco document which explains Cisco 9800 WEB GUI Management : Such As: Dashboard, Monitoring, Configuration, administration, and troubleshooting. About information of CPU utilization and memory utilization.
Dear Community, i have an Cisco C1111-8PWE with embedded wireless controller.From the Router Dashboard i cannot login to the embedded wireless controller.Always shows wrong credentials.If i go over the ip of the management from embedded wireless cont...
I am working on C9120AXI in a lab at school, so this will not be used in production but for education purposes. I followed this link https://www.cisco.com/c/en/us/support/docs/wireless/embedded-wireless-controller-on-catalyst-access-points/215303-emb...
Hello im have this issue where it completely boot looping every time. I've boot into part2 and boot fine connects to my other 2802I which is setup up as WLC. Then begins to download the image from my tftp after this is done reboots and get stuck in t...
Hi Folks, We just bought a Cisco Wireless Controller 9800 and Access point 9166l-AAm trying to join the access point to controller but it is not joining.I can see the blinking Red and Green light on access pointWhen i am checking the logs on Controll...
On a specific Floor we have numerous 9120 AP's and 1 x AP in particular is showing 95% of its clients with very low data rates of under 69Mbps. The AP is automatically setup to adjust its power rating and currently its level is 1/8 ( 23dbm ) which i...
Hi All,I am having an issue where on my SG300 with POE+ it doesn't seem like its giving full POE power to my Cisco AP3702. If I look on the WLC 2504 there is no text box showing POE statistics like I would see if I connected the AP directly to the co...
Not able to add 3800 with mobility express & 9115 EWC in single network. Mobility express delete EWC config if I am connect 9115 ap in network.
Hello All,After Wifi 6 deployments, we have observed that few of our users are randomly getting disconnected. We ran a script and pushed it to the users device to get the logs.We got the below error-Event 4042- Capacity change on {e4c61a7a-894b-4de1-...
hi We have 4 floors of office , recently added a WLC to add extra APs . we have Rukus ap too .we have successfully configured Cisco APs and it all connected to gateway too and WLc (open Security )and APs got ips but our issue is when ever a client c...
