Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello all,we have Cisco Prime NCS Ver. 1.0.2.29 running on a virtual appliance. Since a few weeks the alarm summary shows alarms but the alarm browser window is empty.Any ideas?Regards,Hubert

                  We are starting to experience some dropped connections while utilizing a 5508 WLC (SW: 7.4.100.0) with 2602e LAP's.  The connections seem to drop for 1-2 seconds and then reconnect on their own.  Machines and cards are varied.  Any ...

                   Hi ,We have upgraded our wireless infrastructure from 44xx wlc to 5508 . We have 2 foriegn controllers with HA and 2 anchor controllers , the wireless users were not facing any issues with the 44xx controllers but when we upgraded ...

Hello to all!!I`d like to know if roaming it's possible between radios. I mean: I've some ap with radio a and b/g/n and other only with b/g/n, client roaming between them is possible??thanks in advance!!                

                   Hi All,I tried to install my permanent license of my vWLC running 7.5 version and I change the priority of the eval license from high to low in order to make the pernament (base-ap-count) license to status "In-Used". However, after...

teru-lei by Level 1
  • 797 Views
  • 2 replies
  • 0 Helpful votes

Please help clarify this wording of Cisco's doc. I read through but still NOT clear what's that mean.Wording of A high-gain antenna on an access point will receive a signal from a 5-mW client from a greater distance than a low-gain antenna. It is the...

Currently I have two 5508 controllers each licensed for 100 AP's configured in a 1+N setup with a total of 100 AP's between the two controllers.  (50 each).I am going to add AP's in two remote buildings that are each connected to the core (where the ...

I have just deployed a WLC 5508 version 7.4  with 3602 APs at a Hospital.   The hospital is in process of migrating from a Nortel PBX and Cisco Callmanager.   Currently, they have about 100 spectralink wireless phones, and about 20 Cisco 7925 wireles...

Has anyone encountered this?All devices connect successfully (get ip/dhcp etc) but ONLY Android devices cannot browse the web.It did work for well over a year then suddenly stopped.Ip requests are fine looks almost like failed DNS resolution issue.Se...

jonathang by Level 1
  • 448 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card