Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi All, I have a customer who has CUCM 10.5 and CUC 10.5. Previously when they pressed the messaging key it connectd straight to voicemail. Now when they press the messages key it is ringin 4 or 5 times before connecting. Has anyone come across this ...
when access with via web browser cucm,on the user group screen ı couln't see new button so ı couln't add new group
Hello, I have a VG204 that will not dial out on 2 of the ports, it will receive faxes but when the user attempts to dial out to fax, they are receiving a fast busy. The ports are configured identical to the other 2 on the VG and will receive and sen...
HI i am facing issue with Cisco 7841 sip phone we have CME and CUCM we have more locations recently we got 7841 phones. starting there was no issues but now mostly not registering. The phone always showing in display ( Registering ) only so any bod...
Dears, I have one Cisco CME 2901 with SIP phone 7821 , has been registered and working fine, But after I make a call between phones just the number of recipient phone is appear and the name is dosen't appear! the following configuration of CME : voic...
Hi, We are facing a problem on some of our remote sites in which we have to dial 3-4 times to make a call from 3905 ip phone, where as other models on these sites, like 8941, are perfectly fine and no issue. If we reboot 3905 phone then first 4-5 c...
I want to record all calls at call center ,but when I enable built in bridge option at cisco phone the user can't her us. We use Ip cisco phone 7945G and CP-8841. How can I resolve this issue ?
hi, We have an intermittent issue where we put an external caller on hold and then resume the call - caller can't hear audio. Gateway is mgcp (IOS - Version 15.1(4)M7) CUCM - 9.1.2.11900 Bind commands present in VG mgcp bind control source-interface ...
Hi all I have an issue on an IOS CFB where it only allows 4 participants in a conference ,when you try and dial the 5th participant into the conference it just gives a fastbusy tone. When checking on the router i can see there are DSP slots available...
In a non Cluster environment should this service be disabled so the Alert isn't always displayed? If so I'm not sure how to disable a service in the CLI.
Hi; I have a Viking c1000a door entry controller that is wired to an entry door and my former land line from serviced by Cox. I switched to a VOIP phone line using Ooma service, but now the door intercom does not ring my home phone. How can I conne...
We are in the midst of completing our migration from our Avaya pbx over to Cisco and have run into odd issues with regards to analog elevator lines. While connected on a traditional pbx port we do not experience automatic dialing or noise on the lin...
Hi there,Is there a way to Schedule a restart of a Service in CUCM 6.1?I would like to restart this service below automatically every fortnight or so.. I cant find anything in the CLI or the GUI that will do it..admin:utils service restart Cisco Call...
Hello, We recently upgraded our call manager cluster from version 10.5.1 to 10.5.2 and now we re seeing that the custom wallpaper we use is not working with our 88XX phones. Does anyone here on the forums know if this minor upgrade calls for a change...
We are running RTMT version 11.0. When we select Alert Central, there is Alert History displayed on the bottom of the screen (looks like the last hour or so). How can we: 1) Find or access the Alerts prior to the ones displayed on the bottom of th...
