Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi CCM version : 6.1.2.1000-13System located in Datacentre. IP phones and GW are available are in HQ . Latency response from DC to HQ is 10 ms. Any incoming call through the gateway to the IP Phone the users are able to see the flash first and the...
you state that you want calls from your branch to the HQ to go across PSTN, although people at the branch would dial 5 digits.say a user at HQ has extension 10000, your caller at the branch would call this number, so in order to have it go across PST...
My current plan was the following:Upgrade existing 4.x cluster to 7.x. DMA tool ran fine, loaded onto the 7.x server using same name and IP address.Customer wants to change the hostname and IP address.Whats the best approach? Load the Subscribers ...
hello,I have an issue with dial-peers, when i call one of my did's i get dial tone, the last 4 digits of the did are 8084dial-peer voice 17 voip preference 1 destination-pattern [1-8]... session target ipv4:<ccm-ip> dtmf-relay h245-alphanumericdial-p...
Hello netpro's easy question I think.UCM7 Mobility - I have a mobility profile configured and set up 3 external mobile numbers for 1 phone - when a calls comes into UCM 7 for the phone with mobility configured and all three mobile phone's ring - when...
Hi all,Here an extract of "utils dbreplication status"-----------------------------------Selected node <NODE NAME> does not appear in this replication network; aborting status check operation for that node-----------------------------------Network co...
I have a customer who was concerned witht the fact that configured with full-consult transfer on CME that the Operators number would come across on Caller ID first during a tranfer. Finding out that she basically did a blind tranfer with all calls, ...
I have been unable to find a sample Tcl script which will play a "your call may be monitored or recorded" message to all inbound callers prior to sending the caller to the dialed number. If anyone has a similar script to share or can point me in the...
When a user attempts leaves to leave a message for another user using a Cisco IP phone. The voicemail does not get delivered, but rather the message stays in the sending users drafts folder. Any ideas?Thanks,
Hi all,I have a CCM 6.1 Cluster. The situation I'm dealing with is that Cisco Unified Reporting-> Unified CM Cluster Overview report wrong informations about subscribers (stating that they provisioned but not installed). These information are picked ...
Hi, i need a way to begin in my search :We have a call manager express system with E-phones 7941.Our development service whant to make calls or trace calls on Ephones by using XML syntax. Can somebody can help me ?
Hi friends, I need to know how many DLUs uses a 7911G phone, does one of you have this information?... THXS...
Hi,Is it possible to force the call manager to start a new stream (MOH .wav file played from the begining) for the music on hold each time a line is placed on hold for a dedicated music?I have to configure a MOH for an in-house paging system.The MOH ...
Hii have E1-PRI running on a 2851 voice gateway, the gateway is connected to a port on a core switch, this port belongs to vlan 10.IP phones are in voice vlan 20when a call is made from any IP Phone to pstn via this E1-PRI after some time during the ...
Hi,I have Unity Connection 2.1 tha needs to be integrated with Lotus Domino 7.5. Can someone highlight the pre-requisite & config steps to be done in Unity? It would be very much helpful if someone also can highlight the changes to be done at Lotus s...
