Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
What are all the ports that are used to register phones? Is there a list on Cisco?
I am no CME / Unity Express expert but this seem like a simple question. I have searched high and low and can't find a solution anywhere. HELP.First my setup:SoftwareCME: 12.4(22)T / CME 7.0(1)Unity Express: 3.1ConfigUnity VM Pilot Ext: 200ephone-d...
Installed a Publisher and Subscriber with 6.1.2.1000-13.After upgrading 6.1.2 to 6.1.3 my Subsriber CCM Service not getting started.I have the node licenses uploaded, Done the upgrade for Pub first and then Sub.
hi experts,I am setting the phone proxy features on our ASA 5505. currently our ASA is running vpn bet our sites, say site A and B. Now we wanted to add phone proxy on ASA at site B. Do you think it will work on the ASA at site B?CM---ASA(site A)---v...
Standard users are configured with the ability to call forward to internal extension only.Certain users will have the ability to forwrad calls to there mobiles.To invoke the call forward the users will be given a code e.g #1234, this needs to transla...
HelloDoes anyone know how one can synchronize Active directory contacts with a Call Manager 6.1?I can synchronize The Active Directory Users but I need to also synchronize the contacts that exist in the Active Directory.All help appreciatedVictor
Hello everybody,I have a CUCM 6.1.3 cluster (2 nodes) with 2 GW2811 (using H323), each one with 1xPRI to PSTN.Redundancy is correctly managed for incoming and outgoing calls for all scenarios except one: when a voice GW is network-isolated. The probl...
Customer want to be able to put a call in park and then require the user to enter a PID to be able to take the call. This PID needs to show up in CDR info. Is there any way to accomplish this?
We have UC 2.1.1 and I want to delete a schedule. It tells me is is active, so how do I find which users are using the active schedule so I can delete it?
HI,dial-peers failover occur based on SIP service status or system status?Actually, we have two dial-peers configured with preference 1 and 2 pointing to primary and secondary call server.dial-peer voice 101 voip preference 1destination-pattern 5000 ...
Hi in quest to workaround another problem. I have tried to get abbreviated dialing to work on 7941g phones. On button 2 i have a speed dial configured and then configure extra speed dials from the browser. Pressing 1+ AbbrDial works fine but not fo...
HI all,I'm having a problem dialing one particular 800 number. It use to work and as of a few days ago, it stopped working via CM. The number works fine from any other land line or cell phone. All other 800 or toll free numbers also work fine with...
I have a client that is looking at both technologies. I can not find a document that does a side by side comparison of features between the two. Even the SRND doesn't show what features like mobility, paging, etcd.are offered. Any advice on featur...
I have recently installed CM 6.1 in a VMWare environment for testing. The install went smoothly, but I am having issues now.There are several services that will start, but then they shut down after less than a minute, including the Call Manager and ...
We have a centralized Call Manager 5.1 that hosts three remote sites. Because we have overlap in the digits between the sites we have a code in placet for interoffice dialing over our dedicated MPLS circuits. We are being asked by management to for...
