IP Telephony and Phones

I am trying to get a CM 5.1 box setup in our lab. The server came with the CM software installed and the first time it started up it automatically started the Kudzu program but the server lost power while it was running and now Kudzu is not starting ...

where do I find SCCP/skinny phone firmware for Call Manager Express/CME? I found stuff for the regular Call Manager but can not findy any firmware for CME.

Hi, I am having 7936 conference station. Here we can not mix VOIP with PSTN. So we will be having dual line phones configured in separate partitions and separate Calling Search spaces in most of our customer sites. They are not able to transfer or co...

Hi,I am having Call Manager version 4.2(3). I am having a H323 trunk to one of my gateway. I am having 1024 kbps bandwidth for this link towards this gateway.I want to reserve 512 kbps of bandwidth for my incoming calls through this gateway. How can ...

I have the Cisco Manager Attendant Console version: 1.3(1ES12). How can I arrange the existing Speed Dial Groups (tabs)in alphabetical order and be able to lock it.

Im doing a fresh install of 5.1 and not migrating from 4.2 to 5.1. We want to export the phones from 4.2 with the MACs, DID, display names, etc. Can I do this with BAT?Thanks!Tommer

If the dialpeer have the same preference, this case is default 0. Does that mean the call will be distributed to the two ccms in round robin fashion, meaning one call to ccm1, the other call to ccm2? or the 2nd dial-peer will never used? or the call...

Hi people !Please help me understand what's happening. I have two 2801 with FXO ports, both of them registered with the CM and I can place calls throught them with no problem. They're MGCP gateways.Now I've configured two Route Groups, one for each g...

Is there any monitoring software to view how your traffic is being affected by QOS. Something to verify that a QOS configuration is doing what it is supposed to be doing.

Has anyone every been able to place a call from one IPcommunicator to another over a vpn tunnel? I'm getting one way audio or choppy voice quality. If I place a remote ipcom call to a office phone while on vpn it works properly.

I have a few 7960's that refuse to get an IP address. Even if I configure the 7960 with a static IP address it still does not communicate with callmanager. I've plugged in a known good 7960 into the switch port and it works fine. Everything seems ...

Hello,I have a problem found on 2 routers , they are c2800 with FXS ports ( VIC2-2FXS) , problem that when I connect the phone to port 0 , the 2 fxs ports become off-hook , even if the phone is on-hook , and I can't dial to these ports as they are bu...

Hello Is there a way by which i can configuring the bandwidth for a single isdn channel.We have Isdn pri between mumbai n chennai.This link carries voice as well as data and is configured for DDR.Now the codec used is g729 24kbps with overhead.A...

Below is the partial configuration.My Query is when 3/0/0 and 3/0/1 ports are busy with local calls (calls starting with non zero numbers), then the local calls should be established on 2/1/x which are configured for calls starting with '0'. This con...