Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
have a handful of 7940 phones when you pickup the handset there is no dial tone unless you hit the headset button then it gets a dial tone. Any ideas what can be causing this?
Hello,I need to know what is the version of CME who support the SIP protocol.Thank you in advance
I am having a problem passing audio from one 1760 to another. There is no keying or hooking involved. I need a dedicated always open 4 wire path. Any Suggestions would be helpful.
In the past, I have used the BAT utility in CallManager to create an customized phone report listing all of the active phones and their MAC addresses on the cluster. It's never been the cleanest way to get a simple shot of all the phones because a ph...
To install unity what are the requirements except Unity application, and Cisco Server. Any Hardware Called Voice Cards are required or not.
We try to use IP Communicator 2.1 with the Unified PhoneProxy. IPC needs a very long time for registering. We have seen that it tries to connect serveral time to the CallManager (version 4.2) using port 6970/tcp. This port is new an used for centrali...
Hi Guys, Somebody knows say me if is possible to associate a Caller ID in a FXO port.Thank You
We have 2 call handlers for our office and about a week ago one of them didn't kick in at the time that it should've (3:30pm) Any idea where I can look to correct the issue? Thanks!
I am configuring some 3750 switches for a mitel ip phone solution. The Mitel documentation says to use the wrr-queue command at the interface config mode, but it is not available.
Does anybody have a link or file describing how to do team for ccm 5.x? THanks
I need to confirm if UC 500 supports Softphone....Thanks
what's difference between the two part number? looks the first one is bundle to hardware and the 2nd for additional.LIC-CM5.1-7815=(License CallMgr 5.1 7815 Appliance, 500 seats)LIC-CM-DL-500=(CallManager Device License - 500 units)Thanks in advance,
When trying to bind SCCP i get the following debug error on the gateway:Jun 14 2007 16:34:56.596 UTC: sccp_parse_control_msg: rcvd register rej, reason: Max Phones ExceededWhat does this mean exactly?
I am running Cisco Unity Express 2.3. Is there anyway I can export the CDR an run some of my own reports on it?
We have some 7960s with dual 7914s that are having a problem getting stuck in "requesting template" mode. Apparently SR5 is supposed to fix it. I see 4.1(3) SR5B is out. Anyone have experience with it?
