IP Telephony and Phones

Hi,   Below is my configurations. I want to send calling number 5945151 and called number 0114430432 on SIP trunk. Phone from which i would dial 0114430432 has extension number 151 configured. Is my configuration is correct?   voice class codec 1 cod...

Hi  I have a DID Range 6000 to 6999. I need to block any calls coming to 6751 from Gateway. 6751 should be accessed internally within Office. No External Calls should come to 6751. Please help to achieve this.

Hi,   I've recently setup a CUCM server, which has an H.323 trunk to an Avaya system, which is where all outbound calls exit from.  My Cisco IP phones work fine if the user places a call. However, they are not able to go into their call history and h...

Good day,   I'm tested to configure callfeature long-dur-duration under specific dial-peer as follows :-   dial-peer voice 1201 pots paramspace callfeature long-dur-duration 3 paramspace callfeature long-dur-action disconnect paramspace callfeature l...

Does anyone know if its possible to setup a call waiting option in Call manager when the call will be placed in a queue and then told their position in the queue ?  I have tried find out if this is possible but haven't come across much yet.   Running...

Hello ALL,   I have CUCM 11.5, is it possible we can give option to the user for changing FAC or CAC code..   Kindly advise..

I have recently upgraded our CUCM to ver 9.1.1 from 8.6.I use PRI and only receive the last 4 digits from the telco. When receiving inbound calls I send them to Unity Connections VM Pilot DN 2050.So a PRI call comes DN 2401 and then immediately trans...

I have H 323 G W and i make calls through P S T N but I can't make calls now  here are the shows of voice port 0/1/2 -- fxo-ls up down idle off-hook y 0/1/3 -- fxo-ls up down idle off-hook y 0/2/0 -- fxo-ls up down idle off-hook y 0/2/1 -- fxo-ls up ...

Hi Guys, We have SIP line and CUBE is registered in CUCM. Incoming and outgoing calls are working fine but now problem is that whenver we dial outside using SIP line and then transfer/forward the line to any extension or mobile then call fails. it do...

If a user (attendee) calls in to the Conf Now access via a DID (10 digit) number and enters their attendee PIN, it works fine.  But if the Host calls in via a DID number,  as soon as they enter their PIN, the call drops. Calls initiated internally- i...

Both call transfer to a line group, first call answered but second call dropped when line group members are all busy. All calls were transferred from Cisco Unity {release to switch} option.  I'm expecting it should be on hold or queue but it was drop...