Hello Guys, Can someone guide me if there is any way to get mail notification from cisco prime like If someone does changes inside the production firewall (for eg. add a access rule ) is it possible in any way to get mail notification with informatio...
Forum Posts
Good Morning Everyone... I am in the middle of a large router deployment. There is an updated config that I am having the on-site technician run that includes all of the updated config changes. I am wanting as little on-site technician support as pos...
Resolved! Cisco ASR 1006-X - Crit Led Alarm
Hello,I have a Cisco ASR 1006-X that I cant seem to get the crit led light to go off, I have been under the impression that interfaces that are down, down vs being admin down would cause this but all my interfaces are up, up or admin down.I have atta...
Hi Experts, I wanted to discover all the different devices ( cameras, phones, printers, servers etc ..) currently connected to the access switches, any recommendations what are some of the best commands (IOSXE) or the best way to discover what is con...
Resolved! a Q about sfp compatibility
please if someone can tell me if the attached picture is compatible with my WS-C4507R+E switch module below ports:12card type:10GE SFP+model:WS-X4712-SFP+E
Hi We are running Cisco Prime 3.10 and trying to make use of the topology maps.It has never worked like it should from version 3.3-3.10 Never tryed before 3.3.Some links between switches are automatically showing but not all. CDP is running on all of...
Hi All, Can we provide user access (Read Only) to specific devices using cisco prime..?How?
good afternoon. The manual gave the cisco 2911 and gave the task to create an ipsec tunnel. I connected it to the Internet, configured dhcp, now I'm trying to configure the distribution of the Internet to the local network that the router distributes...
I've created a quick .pdf of the procedure I followed to upgrade my on-prem satellite to the latest version. Hopefully this can help someone out in future.
I have an ASR 1002-X router that has a local DHCP pool. However, while it should have available IP addresses in the pool, it has stopped assigning addresses to new devices. A "debug ip dhcp server packet" shows that it tries to find a relay address b...
i have a 3650 switch that reloaded by itself and checking show ver is giving this System returned to ROM by Critical process fed fault on fp_0_0 (rc=139) at 08:04:57 KWI Sat May 22 2021Last reload reason: Critical process fed fault on fp_0_0 (rc=139)...
Hello everyone, After upgrading my Windows 10 laptop to Windows 11, VPN client CiscoAnyConnect stops working.The error I get is "Connection attempt failed"I have tried uninstalling and re-installing the application, deleting old registry files and ev...
Hello everyoneI have a couple VPN tunnels configured on my Cisco ASA firewall, IKEv1 and IPSec.However when, going to statistics I see 0 active tunnels, even though I have them up and users are currently connected.Am I misunderstanding the terms here...
Greetings Fellow Cisco Heads I am trying to hunt down a white paper to show the benefits of using dedicated switches for virtual host infrastructures (NetApp), can any of you point me in the right direction to any white papers that discusses this wit...
Hi all, Are the following statements correct on how the different ACL works?- Router ACL as applied on a VLAN interface either Ingress or Egress On VLAN Egress Router ACL (e-racl):- All traffic towards the VLAN is allow (i.e. where destination is vla...
