Hi, In the CCME hunt group we can have either sequential or peer. How do I need to configure CCME if I want all phone parts of a hunt group to ring simultanously?? Thanks Alain
We are seeing a perfmance problems with the 7940 and 7960 and a PC connected to them. What we are seeing is that if I have identical pc's connected both through the phone and directly to the Cisco Switch. If we request the same file at the same tim...
I need to connect a RightFax server with an E1 interface, in a 37xx router and route calls using Call Manager to another E1 port connected to a PSTN line. The PSTN line is the main incoming/outgoing voice link to the PSTN.The CM is effectively switc...
Is there any way to set the Clear option per individual directory instead of it automatically clearing Missed, Received and Placed calls at the same time?Thanks.
Hi,Does the user id need to have CTI Use enabled checked and a device associated in global directory for callback server (softkey)?The cisco docs do not say, but am getting event log errors about CTI line open errors on Call Back service from some IP...
Have an attendant that is getting multiple calls on their single line appearance on the phone (7940/60). The problem that they are seeing is that if they are taking a call and a second call comes in, the onlyu softkey option that they have is to ans...
Does anyone know how, or if, you can setup a meet-me bridge for outside, first caller, dialin?We want an outside caller on a non-ip phone to be able to start the bridge.We do not have the budget for Cisco Conferencing Center.Thanks,Michael Clendening
I have been trying to get Xmedius working with various gateways over the last week, and their tech support has been less than helpfull.If anyone out there has a know working hardware/software solution I would love to see it.I used the suggested dial ...
Hi everyoneI'm trying to configure a 1760 router as a SIP Gateway (see attachment for network topology).A PBX is connected on the E1 PRI interface, and has numbers starting with 0030898. What I need to do is make a call from a user A at PBX (i.e. use...
I have this scenario below: switchport -->(10/100Sw)IP Phone_01(PC) -->(10/100Sw)IP Phone_02 The switchport is configured with vlan 102 and auxiliary vlan 99.And the switch is configured with root guard. When I connect two ip phones to the switchport...
If I call my receptionist and have her transfer me to our route point number 6800 it will transfer but when I get to the IP Phone it shows connected on the LCD screen, but there is not audio in either direction. Like the calls legs were not totally ...
Is there any way in CM 4.x to limit the number of inbound calls that can be handled on a shared line. For example, I am trying to share line 1000 on two phones, each phone allowing 2 calls for that line. I want to configure the total number of call...
