Other Collaboration Subjects

I have a 7960 phone with 1 14 key expansion module that is set up for a receptionist. If she on one line and another call comes in on a different line, the only softkey option she has is "answer". This phone has been in place and working fine for s...

I am getting several of the following for all my ATA 188s:Error: DeviceTransientConnection - Transient connection attempt.Anyone else experiencing this?? There are no network issues.CM: 4.1(3) sr1

I am using Cisco 7960 with MGCP load on it. I am getting one way media for inbound calls when my phone announced 21044 as the UDP source port for RTP stream. My query is how can I change the configuration on my phone to use any other port range other...

I have a 2600 that connects to a 3750 layer 3 routing that feeds a 3550 layer 2.The 3550 died and I replaced with a 3750 layer 2 only I can only see the 7912 phones no 7960 or 7940s. The old 3550 could see all the phones in emergency responder. Using...

when creating a line group of 3 lines with the line group distribution algorithm "circular" on no answer, the 3 phones will ring one after each other. (so far, so good) Once they all rang, you will get a busy tone. Apparantly, it is not possible to c...

How can we remove tone on hold completely?AlsoAt present uses hear 3 beep at the start and thats it. Can we change the beeping sequence ( 1 beep 2 beeps etc)and intervalThanksAllan

Im trying to adda subscriber to a cluster but the existing Private Password Phrase is not documented anywhere. Is there a way to view or recover this password?

Could someone point me to any information on the correct procedure to replace a SATA hard drive that is in a raid 1 (mirrored) configuration? I am going to be replacing a fully functional drive in the secondary bay in an MCS-7825-IPC1 server. Do I ne...

What is the max number of conference call participants supported by CME? Can't get more than 3 in a conference call.

I have completed an upgrade cm to version 4.1 from 3.3. All the vm ports now say not found. I have deleted the intergrations and added it again, deleted the vm ports on cm, restarted both servers both still say not found.Any tips of what to do next?T...

I have a remote site where 7912 IP Phones are installed. Users keep complaning that there phones keep resetting to the default settings which means the ring is really loud. Has anyone else seen this problem? Is there a setting in Call Manager that...

I have a few phones that occasionally exhibit the following symptom.An assistant answers a call. She goes to place the call on hold and no softkeys are present and thus she is unable to place the call on hold.We recently upgraded from 3.3(5) to 4.1(...

I need to rest the password on a 7935 conference phone. The factory default admin password was changed from "**#". I need to reset it back to "**#".

I've got a user that travels around quite a bit and uses IP Communicator 1.1.5. The issue is that the software does not ring when a call comes in. How can I troubleshoot this? Thanks

I have a 2611XM with NM-HDV2 and PVDM2-64 modules running on 12.3(8)T8.Question:Is this gateway supported to be configured as a DSP resource in CCM 3.3(3)ES73?I found in http://www.cisco.com/en/US/partner/products/hw/modules/ps5365/products_data_shee...