Routing

I am attempting to setup a home practice wan lab with 3 1841 routers.  Routers R1 & R3 each have 1 wic 1dsu t1 v2 interface and R2 has two wic 1dsu t1 v2 interfaces to connect to R1 & R3.  I am experiencing a problem where the serial connection from ...

We are are experiencing EIGRP flapping between 8 remote sites over a Layer 2 WAN. 3 remote sites do not flap and are configured the same.We are trying to monitor to see if IP connectivity is lost when the flapps occur.Has anyone experienced this type...

Dear All, any body has a documents or conficuration samples for HSRP configuration with BGP with ISP as failover. ( See the attached network diagram)Apprecaite your support.regards

Hi,need know that parameter can to be configured to level of interface as put a channel-group.channel-group X mode [active|passive|on] channel-group X mode on is same that put channel-group X.Need know that parameter without LACP, only want put LAG.

Have an ASR1006 running IOS-XE 03.04.00.S.151-3.S and trying to change the admin distance of a route in a VRF:router bgp 65525bgp log-neighbor-changesno bgp default ipv4-unicasttimers bgp 15 45neighbor 10.47.129.251 remote-as 1234neighbor 10.47.129.2...

Hello,How do you know what peak averages to use in a Class Bass Shaping Mapping for QOS?Thank you  in advance,Jay Swan                  

This should be a breeze for all of you, but I need some help.currently we are implementing a MPLS to connect our outer offices to our main office for voice and data. I've got the voice done already, but need some help with the data part. right now ev...

Hi All,I cannot call via WIC-1AM-V2 and got error message on the router as below. I already verify country code configuration is correct and I dont' found any docs or information relate this error. I checked in the error message decorder but found ot...

How to CONFIGURING THE ROUTER 360 and test for testing purpose---Posted by WebUser Sri Hari from Cisco Support Community App

Anyone know if there is a difference between these (2) mobile wireless router models?MWR-2941-DCMWR-2941-DC-AI can only find mention of MWR-2941-DC-A in Cisco's product documentation.Thanks in Advance!CJ

Hello All,I have a UC520, which is believe has a 100mpbs WAN port. My ISP provides me a 50mbs down / 5 mbs up connection.When I plug my laptop directly into my cable modemn using DHCP and run a speed test, it connects at 1GBps and speed tests show I'...