Routing

Currently all traffic is sent through the mpls network back to corporate for internet.  Added a cable modem for internet to the second interface and trying to send all internet traffic through this interface. I tried changing the gateway to point to ...

Hi everyone  There is a backbone switch and 40 edge switch..I want create 5 users.But I dont want to create every swtich,I want to ceate a user and all edge switch can run this user,how can ı solve this problem?

Hi.I am installing a’ stack with 3st WS-2960S-48FPS with IOS c2960s-universalk9-tar.150-1.SE2bin.I am planning of using Auto-upgrade, and have installed flash:c2960s-universalk9-tar.150-1.SE2.tar on my master switch. But when reloading my stack who s...

Hi Friends, I need some help regarding VLANs. Here is my scenarion:A fiber connection from ISP is coming to a switch supplied by ISP, so only 1 port is active on it. That 1 port is connected to our firewall and then from firewall we have connections ...

hi, i have two different  ISP in my cisco router 2811.local lan:10.10.40.0/24ISP1: x.x.x.xISP2:y.y.y.yi want half of the IP should be working with ISP1 and other half of the IP should be working with ISP2.If any one of the ISP link is down means all ...

Reviewing the PDF of both models, often find that the technical characteristics of the switches outperform small bussines ws-c2960 switches and much lower prices.Someone could clarify the difference lies in that technique and how we are cheaper if yo...

HelloThere are many CAt3560 with IOS 12.2(53)SE2 running in my client's  network.  Recently, those switches have been scanned by a tool  "Netformx" and the report shows that IOS 12.2(53)SE2 is affected by advisory " Crafted ICMP Messages Can Cause De...

Hi,I am very new to high end cisco devices.(like 7600/6500 or ASR9K)Can someone please make me understand why do we login on RP. What actions we can perform after logging-on RP (route processor) or Why they are required ? Cant we  make those by norma...

Hi Experts,                I need your help. From my service provider i have IPV6 address for internet lease line.I want to configure this address in such a way that LAN user can access internet using ip v6. Its easy to configure same senario in IPV4...