Routing

Hi,Can anyone donate to me a cvoice documentation for my educational purposes only. I'm a beginner wo wants to learn.

Hi,We have an Adtran 3200 router connecting a Verizon T1. Every morning, the circuit goes down. Reboot doesnt work. When I call Verizon, they say that they will test the circuit. They call back and tell me that they tested clean till our smart jack. ...

HI,I am confusing which cable i have to choose for 1 port WAN interface,is RS-232 or V.35?Thanks

Hi,Can anybody provide IPSec sample configuration for BRI line. Connection can be initiated from both the directions.Regardsskrao

Dear All, I have cisco router for internet 1841.He has 2 interface as following :-1. Fast Ethernet 0/0 :- Description : connected to My ISP Router FOR INTERNET Connection. . IP Address of this Interface : 213.255.237.109 / 255.255.255.248 2. Fast Et...

Hi,When we have more that one sttaic routes for the same network which one will router will use to route the packet ?For example ip route Network_A / 24 172.30.9.1ip route Network_A / 24 10.9.9.1Secondly if first link is down ( 172.30.9.1) will rout...

Hi,I have some 2600XM routers in my home lab that I need to upgrade to the .8r boot rom.These chips sell for around $50 online at sites like anthonypanda.com.Does anyone know if I can just take one of my .8r chips from an alreadyupgraded router and b...

is vsat module of cisco compatible with DVB-RCS?

I have fully mesh MPLS VPN and RIP between CE-PE routers. I neeed to establish ipsec traffic encryption in the network.What is best practise - to use GRE tunnels, DMVPN or if it is possible to avoid GRE tunnels

Need help please. Have a PPP on two 2800 routers that has been working for couple of months now. One subnet is 172.15.x and the other is 192.168.2.x , I can ping all devices on both sides as long as they are on VLAN1 but I try other VLANS , ping fail...

hi everyone.I have a cisco 1720 router in production and I use the following commands to NAT outbound traffic and PAT inbound.interface FastEthernet0 ip address 10.5.5.1 255.255.255.0 ip nat inside speed auto full-duplex!interface Serial0 ip address ...

Hi everyone,I am curious whether the "polarity" issue exists in the MMF world just as it does in the copper - what I mean is this: just as I need a cross-over RJ45 cable to connect NIC-to-NIC (or switch-to-switch) do I need a cross-over MMF cord to r...

Have 2 3745s with 12.4(3e) and one is crashing and the other one is fine so far. Both have same configuration pretty much except the one has one more T1 card. The one that is crashing and rebooting due to unknown error.3745 uptime is 3 days, 3 hours,...