Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

Hi dear Cisco fellows,I have a 837 cisco router with an empty flash. I am trying to download from tftpserver an IOS image but i always got a Bad Checksum error:rommon 24 > dir flash: File size Checksum File name 9819796 bytes (0...

remarkit by Level 1
  • 2328 Views
  • 5 replies
  • 0 Helpful votes

Hi,???There is a requirement for??measuring exact data flow across interface.? As data in network will always have overheads with??it? ,? like protocol headers, etc .?can we measure? the exact data flow measurement excluding the protocol headers. Is...

amms68958 by Level 1
  • 422 Views
  • 1 replies
  • 0 Helpful votes

Can anyone shed some light on the quote below ?http://www.internetworkexpert.com/downloads/iewb-rs.sample.lab.pdf#search=%22unlike%20igmp%20static%20interface%20command%20when%20a%20router%20issues%20an%20IGMP%20join%22" Unlike the ip igmp static int...

QoS

I see drops on my PQ even. I don't see the queue utilization reaching 128 Kbps when there are drops. Beside the default queue does not drop anything..router1#sh policy-map int Hssi 1/0 Hssi1/0 Service-policy output: test1 Class-map: test2 (match...

Ahmede by Level 1
  • 505 Views
  • 1 replies
  • 0 Helpful votes

Resolved! BERT sync count

We have been testing a circuit and noticed that when the DSX1 BERT sync count increases then the DSX1 BERT k bits (last)goes back to Zero.Please could anybody explain what the DSX1 BERT sync count is, and what it means?

tsalt by Level 1
  • 1753 Views
  • 4 replies
  • 0 Helpful votes

Hi,We have two PIX 515E firewalls working in HA mode.I wanted to configure telnet access to firewalls from outside interface.PIX version is 6.3(5)I kept PC outside to outside interfaces.PIX outside IP is 10.10.200.3, inside IP is 10.10.202.5 correspo...

Can any body let me know any good paper for cUDP Handshaking between two device and how Compression table forms ?Thanks in advance.

hi all,i have purchased one 1841 cisco router and WIC-1T card V.35 cable for a point to point leased line.but now the service provider is saying thers is no line available for this.and they are ready to give HDSL for this point to point purpose will ...