Routing

How do you clear the counters on a T3 controller in a 3660 without rebooting or taking the circuit down?

Hi All, i am having high cpu usgae problem with my Cisco 2621 Router. Router have 1 FE, 2 WIC2T interfaces. On the WIC, 2 of them are working as connections to ISP ( 2Mbps each) while another WIC is designated for 512Kbps VPN. Last week while the to...

We have upgraded our UBR 10K from 2x8 line cards to 5x20 line cards. After the upgrade all ports reported a drop of 5bd, but we have verified that these are invalid reports. Have you heard of this issue? I show no known bugs on Cisco's site, maybe...

We are trying to fine toon our QOS policies and in doing so we are lowering the tx-ring-limit on each of our pvc's.When I lower it to 3 some of the branch locations loose connection back to the main router.The configs on both ends are exactly the sam...

Hi,Imagine if you will a head office and a remote site. Interconnecting the two sites are 2 WAN link's provided by 2 independent ISP's. Each running BGP on there internal networks. At each site there is a 3550 Layer 3 switch. This is acting as the ac...

Hi,I have two location on both the locations 2950 switches are installed. A cisco point to point Wireless link is working (Cisco 1410 Series) i have given them one more Wireless link for redundanncy. When i am plugging this two links on the switches ...

I would like know if there is a specific formula for declare the max number of CRC about a specific interface. Thanks in advance CiaoChristian Biasibetti

I have a 3640 router with 12.1 IOS Version when i am installing NM-2FE-2W-V2, the router is not detecting the Module. is there a patch to fix this problem or someone can provide me 12.2 version IOS supporting Voice & BGP

Hi,I planning to upgrade the new GSR10/200 (Cisco 12410), would like to reuse my existing line cards. Can someone help to verify whether I can insert in this line cards, LC-4OC3/POS-SM= (Eng 0) and LC-1OC12-SM= (Eng 0) onto it. I will use 12.0.31S IO...

hi all...I have 3 IPLC'c terminated on my router.i want to segregate voice an data traffic on these links an also load balance voice on 2 of them and rest 1 is to be used for data.ca someone please help me with this.I have implemented route-maps to d...

Hi people,I have a 1721 router with two wic-1t interfaces, and, in my F0 interface, I have the primary and a secondary ip addresses, I need LAN1 is diferent to LAN2,(IP addresses)In other words LAN1 goes to one wic-1t to ISP1 to Internet and LAN2 goe...

I have configured the following for PBRroute-map pbr-bang permit 10 match ip address pbr-bang set interface Tunnel14 Tunnel15If for some reason Tunnel14 is not available, I would like the traffic to be automatically routed via tunnel15. I shut down t...

Hi,Need you help to fine tune the BGP configuration ,I have three ISP for internet and all the links are connected to different routers. My question is how the traffic will shift to another link if primary link fail. Second question suppose the band...

hello all! I have one CISCO 837 Router, I try configure it trough http, trough is IP - 10.10.10.1 and i can not establish a connection.. When i try to PING it i can not receive data..I didnt change its IP addressI would like to know what is the probl...