Switching

Hi   We have a guest wifi whose SVI terminates on the firewall. I have enabled anyconnect on the inside interface so that I can connect using anyconnect from the inside where the SVI is on a switch.  But I cannot connect if I am on my guest WIFI. So ...

If I have the following AAA configs, do I still need to enter "login loca"  under the line console 0 and line vty 0 15 lines in order to use the local user account configured on the device to access the device if AAA is down?   aaa authentication log...

We are looking at the option of install a Meraki AP at a remote site in instead of a Cisco 2802i access point. We will upgrade the IOS on the 3560-X to ipservices to support VRF tunnels for Guest Internet needed at the location. My question is, can t...

Hi,   We have existing network of core switch and one main router. All vlans traffic was going out from main router. Now, we have decided to isolate guest network from corporate network. So, I connected secondary router with same core switch port. No...

Hi,   does all switches need to have the same region name or it's only locally known ?   I'm talking about this command :   spanning-tree mst configuration  name XXXXX   thanks

Hi, Please help with Access list on the Internet Router restricting Internet access from specific vlan to specific destination and allowing complete Internet access from another vlan.   I am attaching the topology pic, with all the details, please pr...

Hi Experts, Could you please suggest if this is a valid ACL statement.   I want to restrict access from vlan20(172.20.2.0/24 Network) to other vlan. Also need to permit access to my WAN Devices which is of ip address, 172.20.4.2,172.20.4.4 and 172.20...

Hi,I need restricted access to another VLAN for TFTP traffic. So I´ve created an ACL like this:permit udp 192.168.30.0 0.0.0.255 host 192.168.40.10 eq tftpI add this ACL to the source interface (192.168.30.0) as INCOMING.The tftp request to the tftp ...