Switching

We run a college campus with 4000+ clients and two core internal 7206VXRs setup to load balance each vlan's default gateway between them via GLBP.  We use weighted load balancing as both routers are essentially identical in their specs and connection...

Hi experts,I had an incident yesterday that some guy mistakenly removed a port from the etherchannel. However the err-disable didn't catch it and had both ports running which caused a loop and broadcast storm... I want to know how exactly switch dete...

Can I use a WS-X4596 in a CAT4506-E or a WS-X4596-E in a CAT4506?Does the E means Enhanced or High Speed FAN.

Can I have a switch uplink with a SFP-10G-LRM(Plugged into a 3560 with a c3kx-nm-10g card) at one end and X2-10G-LRM( Plugged inot a Catalyst 4500 E ) at the other. I am using OM3 MMF I know they both use 1310-nm wavelengths Both I was unsure if they...

Aloha All,I did some research and found some possible partial answers but not a complete answer to the following question.  If you have a router with multiple direct vanilla FE (non trunked) interfaces on a switch trying to send QOS tagged packets to...

Is possible to make "masquarade" on no switchport interface on ME3400? And is possible add different "WAN" IP for each port?Thank you!BRDave

HelloAll our  access switches are configured with default vlan IP ( i.e ) Vlan 1 - IP Range 192.168.1.0 255.255.255.0On applying management vlan IP we dont have access to switches via telnet or sshhow to secure the user-switch from accessing from def...

Hello, I am trying to configure a 3750 48 port switch and having trouble with getting it to see the sfp. I just want to set up the router with a pretty basic set up since I am using it for a ping test between 2 buildings, via fiber. Could anyone plea...

Hi,I have CISCO 2960 switch at my LAN. Kindly guide me for how to configure its IP address from console or hyper terminal ?

hello,I have issues logging into one of our core switches.its a 6509 switch but i cannot log in remotely.when i try to console in on the console port, i cannot log in instead i get the above error message.I haven't rebooted yet but would it solve the...

Hello all, I have to entry points to our data center - mpls and b2b (backup).  I want the backup b2b to be automated and not manually if the mpls goes down.  Ingress from the b2b I have switch running ospf with the firewall and redistributing those r...