Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi,I've noticed some unusual behaviour with output discards being demonstrated by our 3750 switch stacks that are running IOS 12.2(50)SE and above (IP Services and IP Base). Our edge switch estate is made up of 3560s and 3750 stacks of which the bulk...

bgfl-tech by Level 1
  • 1791 Views
  • 1 replies
  • 0 Helpful votes

Resolved! trunk negociation

Hi,Which configuration option will cause the link between 2 switches to become a functional trunk?1. switchport access vlan 31 switchport mode dynamic desirable2. switchport mode trunk switchport nonegociate3. Leave the port with default trunk settin...

boboshlap by Level 1
  • 604 Views
  • 7 replies
  • 0 Helpful votes

I have 1 cisco 2960G connected to  core switch 3560G. The uplink port from 2960G to 3560G is occassionally  showing high utilization of 40% between 300MB-400MB during the night.How can I find out what kind of traffic or applications that is occupying...

yeow_km by Level 1
  • 263 Views
  • 1 replies
  • 0 Helpful votes

I have a SRW248G4 switch but I can't log into it.  Can anyone assist?  The default IP address 192.168.1.254 doesn't seem to work.  Thanks.

En Español:Estimados:Estube leyendo sobre el metodo password recovery, lo que no entiendo bien es si yo hago eso puedo llegar perder la configuracion almacenada en el Switch?, y tambien quisiera saber sobre donde conseguir el Cisco Visual Switch Mana...

Hey,Our design consists out of 2 VSS Systems interconnected with a 4 x 1GE bundled in an etherchannel. These uplinks are terminated on the supervisor and each supervisor is terminating 2 x 1GE.Recently we had a failure of a supervisor engine in one o...

Gurus,I've got a couple 6513 switches acting as our layer-3 "core" and thus have multiple VLANs and are responsible for the routing between them. The switches are running EIGRP to build the routing table between them and other routers as well. The tw...

Hey guys,Not sure how to search in this forum and I am sure this has been answered before so sorry if this is repetitive.I have a small office and we have recently upgraded to RV4000 router. Since the upgrade our LAN speed is ridiculously slow in any...

I have 2 3560G as core switch but 1 is current as standby in case the first switch fails.I am tasked to setup HSRP on both switches.so that core switch01 is the active while core switch02 is the standby.currently the 2nd switch is not populated.it is...

yeow_km by Level 1
  • 1420 Views
  • 6 replies
  • 0 Helpful votes

Hi to all,  I Know that this question was discussed many times, but I didn't find a clear answer and I still can't find any solutions to my issue.I've recently added a second subnet (192.168.2.0/24 in diagram) to the inside interface of my PIX that c...

edp_cisco by Level 1
  • 475 Views
  • 6 replies
  • 0 Helpful votes

Hi,I have a stack of 4 no.s of 3750-X switches all switches are currently running IPBase, now i want to upgrade IP service licence on two of them. Could any one please point me towards the documentation to upgrade IPservice licence in heterogenous en...