Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

HiI have to order a Cisco WS-C6506-E switch Chasis with VS-S720-10G-3C Sup with redundanncy and WS-X6748-gE-TX and  WS-X6748-SFP modules.I would like to know about the Smartnet Part for the same for 3 years. how can I find te SmartNet Partnumber for ...

below is the buffer allocation for the queues on the interface, is it possible to see the total queue size what is utilized in percent for each queues, i.e, total packets in each queue and what is remaining, if the queue is full or not..I am after a ...

hi every bodyi hope every body is having happy holidays.  I have few questions.Routers in Internet are configured to drop packets, destined to private ip addresses.  How do we accomplish this ?  by using acl?Let say an isp router  receives a packet f...

sarahr202 by Level 5
  • 2593 Views
  • 6 replies
  • 0 Helpful votes

Hi all,i'm having some problem in redistributing static route in eigrp with vrf configured.i'll show you configuration:Device Aversion 5.1(1a)feature eigrprouter eigrp 667  autonomous-system 667  vrf BB_backend  address-family ipv4 unicast    redistr...

Hi,Right now we have about 30 switches (2960 and 2950) and a switch core Catalyst 4507R, we're traying to hard our network plataform and surfing the web we have found many documents and recommedatios pointing to activate Dynamic Arp Inspection in the...

Can anyone shed some light on how to estimate power draw on N7K when all interfaces are up on a module? Here's an output from my n7k:show environment power Power Supply: Voltage: 50 Volts Power                              Actual        Total Supply ...

Resolved! VLAN

Hi All,First of all I am very new to cisco products.Can someone give me any example config how to create a VLAN in L3 switch Cisco 4507rIt would be great help to me.Jopeti.

jopetik09 by Level 1
  • 850 Views
  • 3 replies
  • 0 Helpful votes

Hi I have two 6500 chassis and plan to upgrade the supervisors from sup32 to sup720.What is the correct procedure to do this?I imagine it's the following but I'd like to be sure.Backup configpower down switchboot off new sup720restore configMany than...

Hi,Is it mandatory that Native VLAN on the both sides of the trunk shoud be same? By default VLAN1.If it is configured in-correctly will the trunk form?If native VLAN must be same - what is the reason for this, probably DTP will not communicate or an...

I'm thinking about updating my IOS software on my switches.What's the difference between IP Base and IP Services?  I have 3560-48ts and 3750-48ts  switches.      I wish to have the Web interface for controlling these switches as I'm not experienced a...

Our core router suddenly rebooted and we are convinced it is do to loss of power but we want to be certain, here's the show ver:Any advise?Cisco IOS Software, 2800 Software (C2800NM-ADVSECURITYK9-M), Version 12.4(25b),RELEASE SOFTWARE (fc1)Technical ...

I have a LAN that has 2  3560's  48TS ,  1 on each end of the building,  connected via twisted pair SPF ports.   I'm currently using all 4 channels. I have just one Vlan.   I have some spare 3750's   48TS ,    and I just stacked 2 of them and wish to...