Activity in Technology and Support
Multi Phase 2 connections with IPSec Site 2 Site
ive got a problem i cant seem to figure out. When my Ipsec tunnel is built it makes a new phase 2 connection every 60 seconds. 1.1.1.1 = Cisco Router2.2.2.2 PfSense Router----- Connection configuration -----1.1.1.1 => Internet <= 2.2.2.2-------------...
How to move AP from secondary WLC to primary WLC in N+1 in wlc 9800
How to move AP from secondary WLC to primary WLC in N+1 in wlc 9800
Looking for Help or a Guide for Writing Basic Config File
Good Afternoon All,Looking for kind of a step by step guide. My org recently purchased 3 9300L switches. Two of them are 24p's and the other is a 48p. I am assuming I can write one file then make small tweaks due to the port capacity. These switches ...
About UCS B series or UCSX vhba pin to fc uplinks
Hi All, I wonder , if there 4 fc uplinks on each FI A and FI B (no port-channel), there are 2 vhba on each blases and goes to FI-A and FI-B, no config pin group. If there is fc uplink down, the vhba pin to the down port will be repinned to other av...
CUCM Publisher and Subscriber Redundancy and Failover
Dear Team,I have configured CUCM Subscriber at the branch office and added it to the existing publisher at the head office. Now Pub and Sub sync is well, and all phones are registering to sub if pub is disconnected from the network. Incoming calls al...
Resolved! Criteria for a network to be strictly "Layer 3" vs "Layer 2"
Hello all,I have read about networks being described as "only Layer 3," and as such require no STP protocol, examples being VXLAN-based networks like Cisco SDA or ACI.However, even these networks have VLAN's (like L2 VNID's in SDA), and they also sti...
Posture assessment report never finishing
im trying to run a scheduled report for posture assessment by condition filter last 7 days. first one I scheduled after 48 hours it was still listed as "in progress" created a TAC, engineer and I went through root to clear out the jobs. Set the j...
FMC does not log HTTP/HTTPS Connection Events
Hi everybody; My lab consists one FMCv with version 7.4.2.3 and one FTDv in Routed mode with version 7.4.2.3. I have created an Access Control Rule with the following conditions: I have also configured the logging operation as follows: Now when...
Cisco ISE Unauthenticated Remote Code Execution Vulnerabilities
Cisco Identity Services Engine Unauthenticated Remote Code Execution VulnerabilitiesIt stated that: "If Cisco ISE is running Release 3.3 Patch 6, additional fixes are available in Release 3.3 Patch 7, and the device must be upgraded". What the hel...
EAP-TLS Device Certificate for Entra Joined Devices with Intune
In my environment, we have some devices that are hybrid AD joined and some that are only Entra Joined. I'm using SCEP certificates that are being issued by a third party CA. I'm running Cisco ISE 3.3 Patch 4. I've set the SCEP profile so that there a...
VLAN issues
I recently replaced the core switch at one of my sites that consisted of two separate C9300-48Ts and three other off brand switches and installed a new stack with a C9300X-48HX, C9300-24S and a C9300-48T (running 17.12.5). This is a layer 2 network c...
ResourceWarning: unclosed
I'm running the following simple script:from dnacentersdk import DNACenterAPIapi = DNACenterAPI(USERNAME, PASSWORD, base_url=BASE_URL, verify=False) res = api.devices.get_device_list() print(res)And I get a warning:sys:1: ResourceWarning: unclosed <s...
Cisco 5508 Controller – LAG Mode
Hi everyone,I need to know if it’s possible to configure the Cisco 5508 Wireless Controller to use LAG mode with LACP.The controller is running version 8.0.133.0.I’m migrating this controller to new Cisco Meraki 9300M switches managed through the Mer...
List versus Leaf-List nodes in YANG
Hello, everyone. I am studying automation for my ENCOR exam. I have a quick question - what is the difference between a leaf-list node and a list node in YANG models? Google defines them as: Leaf-list node — Contains a sequence of leaf nodes List nod...
License webex
Normally, if I buy a Licesen Register, do I need to buy an additional webex license?
| User | Helpful Count |
|---|---|
| 95 | |
| 89 | |
| 89 | |
| 75 | |
| 61 |
