Unified Communications Infrastructure

The Powers That Be decreed that our users would be confused by the large number of notification devices, so our development team took a look at the SQL tables and stored procedures used to create users, etc and altered Unity.It's now a few months lat...

Hi there,We perform Exchange 2003 upgrade to SP2 and Windows 2003 to SP1 and now we are having intermittent login problem when we try to access the System Admin page. There is no error message in the Event Viewer. We are running Unity 4.0(4). I have ...

I have a Unity Lab server and decided to remove Unity, Exchange and SQL and reload it. Not such a good idea! I got everything reinstalled, but Unity won't start. There's a list of errors.Event ID: 30003Source: CiscoUnity_MALExDescription: An attem...

I have CUE 2.1.3 on 2821 router, which was working fine until I upgraded the IOS of the router to 12.4 and upgraded the CME to 3.3. I can not ping the service-module from anywhere except the router, thus I cannot connect to the web GUI. I've tried us...

The router to Unity T.37 FAX service is billed as, “The Cisco Unity IP Fax toll is intended for simple, small, low-traffic fax environments.” Having said that, are there any safe guidelines on the number of FAXes it will handle for incoming use only?...

Is this configuration supported ?A unity subscriber sends a fax via email to a destination fax and say that machine is plugged into a vg224 (under control by Callmanager). Unity sends the fax using t37 to the voice gateway. Voice gateway receives the...

I am running Unity 4.0.3 sr1, I would like to find out if it is possible to run the Unity Failover Wizard on the secondary Unity server at a later time once you ran it on the primary server.any help is appreciated !!!Thanks !!!Danny

CCM 4.1.3/Unity 4.0.5 - We have a shared line that during business hours, exhaust the 1st 4 lines and then sends the 5th call to a VM rather than a busy signal. We have an after hours and an away greeting that allows VM during that time but we do not...

I just want to move voicemails from 4.05 to a 4.2 unity server in a different. Is there a documented Cisco way of doing this? I know the microsoft way that is documented of migrating Exchange servers.Is there a tech doc for this?Thanks!

Dear All We are currently facing a problem with ccm 3.3(4)Set up We have a call manager as in publisher and subscriber at Mumbai .Also we have accm 4.01(3a) at UK and have a connection through the intercluster trunk link.At uk they users who d...

Hi, we are looking into converting Cisco conference connect, to Meeting place Express, might use a MCS 7835, or MCS 7845.Wanted your help on how long I should consider for the install time, Would like to see a detailed Cisco Doc if any with the steps...

We are centralizing our Unity system to our corporate site. We currently have Unity at each remote location that use Call handlers extensively. My question is for each call handled Unity will stream the message across the Wan so in effect if 5 peop...

I just ran the failover wizard on both primary and secondary server last night and all went well. This morning I found that the secondary server went active while Unity still running on the primary server and all voicemail ports on the primary serve...

Hi,i have Unity 4.0(4) Unified Messaging (integrated with Exchange 2003) on Windows 2003. When a certain extension tries to leave a voicemail to other people internally we get this in the event viewer. Source: CiscoUnity_ConvMsg Category: Network Eve...

Hi, Is Unity will work if :- Some Users are in a old Domain- Some Users are in a new Domain- All Users mailbox are host on an Exchange in the New Domain ?There is a full trust between both domain the old and the new oneIs Unity will have a problems w...