Hi We are planning to move our Cisco UC (11.5) VM's to HP as our UCS are EOL and we want to utilize our HP servers.As per discussion https://community.cisco.com/t5/ip-telephony-and-phones/move-vms-to-new-esxi/td-p/3868023 ,we will stick to option 2 ...
Forum Posts
Hi,I have an E1 line with a range of numbers (ex: range 312 3400 - 312 3499)How can I forward calls to specific exceptions received to a specific number?(Ex: calls coming to 312 3420 need to automatically send to extension 2422) in general conditions...
Came across this the other day, a CUCM installation using UCL licensing showing licence violation. The cause was two phones with the same owner ID, as a result it was looking for at least an Enhanced Plus licence. I am fairly sure I've seen it simp...
i have Ms Active directory infrastructure, at the same time i am deploying the CMS as well as the CUCM as on-premise collab infrastructure with a single split deployment, soo how will the LDAP be done?, will i connect the LDAP with the CUCM , and th...
Hello, I have a customer wich has in contract the swiss's below for CUWL Pro Licensing: CON-PSBU-CUWLLIC for P/N CUWL-LICCON-PSBU-IPDEVUWL for P/N PUBLIC-IP-DEV-UWLCON-PSBU-DEVUWL for P/N ANLG-DEV-UWLHe has CM version 11.x and wants do upgrade for ve...
Hello All, I have a user that would like to tag voicemails sent to email to be able to easily distinguish between a voicemail that was left for a user because the caller dialed their extension versus a voicemail that was left because the caller diale...
Hello, I hope you are well. I am facing the following error.In find and list device profiles one searching for any profile the message is displayed:Unmapped Exception com.cisco.ccm.dbl.TypeTables.TypeDeviceProfilein Actively logged in devices:Once op...
close
Dear Members, I have deployed the MRA for once of my clients. Jabber login completes successfully with no issue at all. However, I am unable to register my DX650 device. I also agree the fact that this is an andriod based device and needs Certificat...
Dear experts,Need one help.We have a Hunt pilot in CUCM under which 2 line groups are there.When call comes it hits first line group extension and Remote destination.But when the call jumps to 2nd line group only extension rings not the remote destin...
HiMy customer run a cluster of CUCM Version 8.6 with G722 codec disabled. We plan to enable it by setting to enable Enterprise Parameter "Advertise G.722 Codec" and by checking Service Parameters "G722 Codec enabled"I am not sure if those two action ...
Users are complaining that their PCs are slow when connected to the network through Cisco IP phone. Speed is regular when PC is plugged directly to the network switch. Access switches where IP phones are connected are mostly Cisco WS-C3560-48PS. Most...
Hi,Is there a way to set up SIP trunk monitoring in RTMT and send an email alert for a status change of the SIP trunk ? Thanks in advanceAjith
Hi After using the method in axl updatelinegroup the lineselectionorder is not reorder of the linegroup if I remove linegroup number 4 the lineselectionorder would be 1,2,3,5,6 .. it does not reorrder after doing a getlinegroup, I have noticed wh...
Hello Everyone. I have a doubt. I get a end customer has a Cisco Gateway ISR 2911 with 15.0(1) M4 (c2900-universalk9-mz.SPA.150-1.M4.). My question is, ¿ can I directly jump to the cisco recomend version 15.6(3)M8 ? or ¿ I should to upgrade some vers...
