Unified Communications Infrastructure

It's been a little while since I used PCD and wanted to double check a couple of questions (this is a 10.5 to 15 migration): 1.) If I'm reusing the same hostname and ip addresses (or different hostname but same ip) from the existing CUCM cluster, can...

I'm struggling to find the instructions on how to install a CA signed HTTPS certificate to PCD. Can anyone point me at the right place?Thanks,Gordon

I am considering using PCD to upgrade my customer from 12.5 to 15. I wanted to check how PCD manages the change of versions. When I have done upgrades in the past where the customer wants to maintain service to phones I can upgrade each node in turn,...

Currently I have a 2 node CUCM 12.5 cluster running on ESXi 6.5 that I'm looking to get to version 15.  Based on the v15 upgrade guide this is possible, but CUCM v15 isn't supported on ESXi 6.5, or at least not tested.  Is the best option to try to d...

I have been working with the Prime Collaboration Deployment tool in the lab trying various things with it.  I like the concept of what it is supposed to do, but in practice it fails far more than it succeeds.  Of note: 1.  If a presence server is hoo...

I'm not sure if this is possible or not, but I'm building a new CUCM/Unity (14.X) deployment and am trying to automate it for the following workflow:Extension assigned to a user's ipPhone attribute in Active Directory.User with extension in LDAP sync...

Hi, Newbie again here, Why would Prime licensing manager suddenly be in demo mode after 2 years of use? All licenses, seem to be gone. Thanks, Sam

PCD Migration fails with DNS invalid or not reachable though the DNS IP is reachable also DNS record is valid,  we are ending up with unsuccessful migration

I am planning to deploy new VMs including CUCM version 14, Unity Connection version 14 and UCCX version 12.5 in a new ESXi envrionment with new support. Because the old solution with BE 6000 M4 is end of life. For CUCM and CUC, the Install with Data ...

Anyone solved this issue when installing Cisco CUCM Version 14 I tried the following versions: 14.0.1.13900-155 and 14.0.1.12900-161 but I get the same and following error. I found some old discussions about this issue without a clear solution.    

I have 3 ephone  2 of them have 1010 ,1020 number and I want to make the calls from fxo port comes on both of them so  I make a voice hunt group with pilot number 30 , now I want to make barge to this number 30 if any of 1010 or 1020 have call from f...

Hellow guys ,Can someone help me in why the get failed to setup barge in my cisco cme setup ?cme configuration 

Hello guys,I want to make cbarge on my ip phone 7945 but it gives me "failed to setup barge" .if anyone has this problem and solved please tell me , here is the configuration of my cme CME configuration