Voice Systems and Accessories - Small Business

Hi All,I'm currently (pain-stakingly) trying to do what should be a simple task of upgrading a number of 7945's on a UC520.CCA is 3.3.2 and the UC520 on 8.6.The 7945's are on 8.3.2, Im trying to go to 8.5.2.Any attempt to drag and drop results in the...

Hi - I have an SPA 504G  with SIP service and use a third party conference service to host conference call.  The 3rd party service requires me to log in as the Leader and to do this I have to press the * key.  This doesn't work possibly becuse * has ...

I have a system in Key Mode, and cannot seem to figure out how to get an analog phone that's plugged into the FXS Port to make an outgoing call.

Hello all,Has any one had issues or success upgrading the firmware of a SPA122 remotely?I have the parameters set the same way as my 2102's and I do not seem to get my device to pull the firmware.Any thoughts?

Has anyone successfully installed and configured the Linux Version of Provisioning manager that came with the BE6000 8.6 bundle?I can get the IP/Network config done using the Quick Start Guide, but then the guide references logging in with admin, and...

I have this ugly issue where I have 3 pots lines from Verizon going into a UC320W and when my client makes outbound calls sometimes while dialing the phone just drops ... and the phone display goes back to the main screenI got some logs (other than s...

Hello All,My UC520 issues continue.  After much frustration and assistance I finally got my SIP trunk running and all appeared to be well.  Calls and DDI's were working great.  I though job done. However, another issue has popped up.One of the staff ...

Anyone having issues with CWID on the SPA122? The call-waiting call beeps but doesn't show the caller ID name or number. I'm running the newest firmware 1.2.1-004. I've seen complaints about general caller ID issues with the older firmware but not wi...

Hello, I have to configure "Fax 2 email" in a UC540 and I have no experience.The connection of the fax machine is on FXS ports.The email account is a gmail.I just need to set the incoming fax to gmail account.Someone has configuration information.Tha...

Hi all, I have been trying to rebbot my Cisco spa508 using XML IPPhone Execute <ExecuteItem URL="Resync:http://ip address/admin/reboot... it works fine, but if the admin pasword is set it stops working.I have tried with the admin and pasword in the u...