Voice Systems and Accessories - Small Business

GReetings to all,I have a UC520 and I have a 1 SIP inbound that rings a blast group to ring the phones around my house, but I would like to have it so when someone leaves a voice mail that the MWI goes on all the phones...I found an old post (from 20...

Hello Dones anyone have the steps in doing this.  I am trying to use Easy VPN Remote but it seems liek its not working at all. I have 3 of them to configure but for the life of me itsn ot working.  I want to connect the 891W router to the uc560 and a...

II wanted to tell you all I kinda disappeared from the community for the least several weeks as I had to consider a change in my career.I decided to leave Cisco after 12 fun years, the most fun being out here with you all, perfecting my skill in 'tec...

I have installed a few of these systems and have always came to this site for information.  Well, this last system I built, I let the customer know about the "FREE" VeraSMART Call Accounting Software which according to this site is still FREE.https:/...

in most calls when I hang up , the device will reboot (all leds dies then red will flash, then regular boot sequence).syslogd says: reboot reason : H0 (i.e. hardware reboot) which really doesn't help much.the issue is that it won't send BYE upon such...

Hi all,We have a site with a UC560 with a number of SPA504G phones attached.The site has a SIP connection on which it makes outbound calls.We would like to add a "9" to all missed or received calls under the directories button on the phones.I can't s...

Hello,We've a customer with a UC320 and some phones plugged into a SG200.Systems works OK for a few days, but then the phones become unregistered to the UC320.Having seen the "UC320 requires ESW firmware 2.1.19" notification - is there a similar noti...

What is the appropriate header to send to a 525 to get it to 'auto-answer'?Assuming that the config settings are correct (Auto_Answer_Page = Yes, etc.), we have the following -    * On the 504, if the incoming INVITE contains the header   "Alert-Info...

After upgrading UC520 from Pack 7.0.3 to 8.1.0, MWI stopped workingExtension 222MWI On A800...MWI off A801...below is debug output from CUE2307 06/30 08:21:01.515 voicemail mwi "refreshMWI" 222 02307 06/30 08:21:01.541 voicemail mwi "setMessageWaitin...

Hi forumI'm testing a SPA504G.  Seems mostly working quite well, but small problem with 2 channels.I have single voip line with 2 channels from voip provider.I need to have both channels active using Ext 1 and Ext 2 buttons, so that conference calls ...

Hello, I have a uc560 running and all is well.  All phones registered under "show ephone reg".  I can pull up the gui under /ccme.html and i see everything but phones.  I can pull up the CUE gui and  go under users and see the phones listed with thei...

Hi Is the ATA PAP2T compatible with the Cisco Callmanager Express, if yes wich versionthanks

I have a problem with a Voip solution between a SPA3102 and a PAP2T through a radio link. The communication disconnects/falls at random between minute 1 and minute 5. I tried the service quality and CCQ changes from 100% to 95% with only a 80 K bandw...